Petra Urbancová

Mrs. Petra Urbancová

Department of Physics, Faculty of Electrical Engineering and Information Technology, University of Zilina, Univerzitna 1, 01026 Zilina, Slovakia
orcid

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
13 November 2019 in Optics Letters
Verified
Journal Article
Closed access
PDF file
PHPetr Hlubina
Petr Hlubina
PUPetra Urbancová
Petra Urbancová
DPDusan Pudis
Dusan Pudis
MGMatej Goraus
Matej Goraus
DJDaniel Jandura
Daniel Jandura
DCDalibor Ciprian
Dalibor Ciprian
We demonstrate an ultrahigh-sensitive plasmonic sensing of gas, employing a two-dimensional (2D) dielectric grating fabricated by laser interference lithography. The 2D grating was designed with the period of 500 nm and prepared in an AZ1505 photoresist layer on a gold film of 20 nm thickness deposited on a fused silica glass substrate. The surface plasmon resonance (SPR) in the Kretschmann configuration with spectral interrogation was utilized to measure the response of the sensor to vapors of aqueous solution of ethanol. Based on measurement of the gas refractive indices with the reference Au/Cr/SF10 sample, the resonance wavelength dependence was obtained. The SPR response of the structure in a spectral range of 1.68–1.85 µm with a sensitivity of 8200–111,000 nm/RIU was revealed. The sensor provides significantly higher sensitivity in comparison to conventional and grating-based SPR sensors.

15 October 2019 in Optical Materials Express
Verified
Journal Article
Open access
PDF file
PUPetra Urbancová
Petra Urbancová
DPDušan Pudiš
Dušan Pudiš
AKAnton Kuzma
Anton Kuzma
MGMatej Goraus
Matej Goraus
PGPeter Gašo
Peter Gašo
DJDaniel Jandura
Daniel Jandura
In this paper, we present a manual for the preparation of fully functional woodpile structures with partial photonic band gap (PBG) for applications in the visible (VIS) spectral range using an attractive polymer IP-Dip that is novel in photonic applications. In an experimental preparation of polymer-based woodpile structures using the IP-Dip polymer with partial PBG in VIS spectral range, a single-step laser lithography technique based on direct laser writing (DLW) was used. The woodpile structure preparation is based on a complex theoretical analysis of dispersion diagrams for the woodpile structure with fcc symmetry and IP-Dip polymer. We found partial PBGs in the Γ - X direction and dependence of PBG on the filling factor. Using a conventional DLW lithography system, we prepared a series of low-periodic woodpile structures with PBG in NIR and VIS spectral range attacking the yellow-green spectral range, which can be easily applied on different photonic components.

1 December 2018 in Applied Surface Science
Verified
Journal Article
Closed access
MGMatej Goraus
Matej Goraus
DPDusan Pudis
Dusan Pudis
PUPetra Urbancová
Petra Urbancová
IMIvan Martincek
Ivan Martincek
PGPeter Gaso
Peter Gaso

27 November 2020 in Sensors
Verified
Journal Article
Open access
PDF file
PUPetra Urbancová
Petra Urbancová
JCJakub Chylek
Jakub Chylek
PHPetr Hlubina
Petr Hlubina
DPDušan Pudiš
Dušan Pudiš
In this paper, we present a new type of guided-mode resonance (GMR)-based sensor that utilizes a planar waveguide structure (PWS). We employed a PWS with an asymmetric three-layer waveguide structure consisting of substrate/Au/photoresist. The ellipsometric characterization of the structure layers, the simulated reflectance spectra, and optical field distributions under GMR conditions showed that multiple waveguide modes can be excited in the PWS. These modes can be used for refractive index sensing, and the theoretical analysis of the designed PWS showed a sensitivity to the refractive index up to 6600 nm per refractive index unit (RIU) and a figure of merit (FOM) up to 224 RIU−1. In response to these promising theoretical results, the PWS was used to measure the relative humidity (RH) of moist air with a sensitivity up to 0.141 nm/%RH and a FOM reaching 3.7 × 10−3%RH−1. The results demonstrate that this highly-sensitive and hysteresis-free sensor based on GMR has the potential to be used in a wide range of applications.

29 April 2021 in Nanomaterials
Verified
Journal Article
Open access
PDF file
PUPetra Urbancová
Petra Urbancová
DPDušan Pudiš
Dušan Pudiš
MGMatej Goraus
Matej Goraus
JKJaroslav Kovac
Jaroslav Kovac
In this paper, we present a two-dimensional surface plasmon resonance structure for refractive index sensing of liquid analytes. The polymer structure was designed with a period of 500 nm and prepared in a novel IP-Dip polymer by direct laser writing lithography based on a mechanism of two-photon absorption. The sample with a set of prepared IP-Dip structures was coated by 40 nm thin gold layer. The sample was encapsulated into a prototyped chip with inlet and outlet. The sensing properties were investigated by angular measurement using the prepared solutions of isopropyl alcohol in deionized water of different concentrations. Sensitivity of 478–617 nm per refractive index unit was achieved in angular arrangement at external angle of incidence of 20°.

6 September 2022 in Nanomaterials
Verified
Journal Article
Open access
PDF file
JCJakub Chylek
Jakub Chylek
PUPetra Urbancová
Petra Urbancová
PHPetr Hlubina
Petr Hlubina
JSJaroslav Sobota
Jaroslav Sobota
Dusan PudisDusan Pudis
Dusan Pudis
In this paper, simple and highly sensitive plasmonic structures are analyzed theoretically and experimentally. A structure comprising a glass substrate with a gold layer, two adhesion layers of chromium, and a silicon dioxide overlayer is employed in liquid analyte sensing. The sensing properties of two structures with distinct protective layer thicknesses are derived based on a wavelength interrogation method. Spectral reflectance responses in the Kretschmann configuration with a coupling BK7 prism are presented, using the thicknesses of individual layers obtained by a method of spectral ellipsometry. In the measured spectral reflectance, a pronounced dip is resolved, which is strongly red-shifted as the refractive index (RI) of the analyte increases. Consequently, a sensitivity of 15,785 nm per RI unit (RIU) and a figure of merit (FOM) of 37.9 RIU−1 are reached for the silicon dioxide overlayer thickness of 147.5 nm. These results are in agreement with the theoretical ones, confirming that both the sensitivity and FOM can be enhanced using a thicker silicon dioxide overlayer. The designed structures prove to be advantageous as their durable design ensures the repeatability of measurement and extends their employment compared to regularly used structures for aqueous analyte sensing.