Ivana Presecki

Dr. Ivana Presecki

Department for Environmental Engineering, University of Zagreb, Faculty of Geotechnical Engineering, Varaždin, Varaždinska Županija, Croatia
orcid

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
27 October 2020 in Applied Sciences
Verified
Journal Article
Open access
PDF file
Szymon MalinowskiSzymon Malinowski
Szymon Malinowski
Ivana PreseckiIvana Presecki
Ivana Presecki
IJIgor Jajčinović
Igor Jajčinović
IBIvan Brnardić
Ivan Brnardić
VMVilko Mandić
Vilko Mandić
Ivana GrčićIvana Grčić
Ivana Grčić
The work is focused on the assessment of possible methods for intensification of photocatalytic degradation of common water borne pollutants. Solar photocatalysis poses certain limitations for large scale application with several possible reactor designs which have shown an optimal performance. In the current study, a comparison between two types of pilot scale reactors was made: a flat-plate cascade reactor (FPCR) and tubular reactor with a compound parabolic collector (CPC). Apart from the reactor design, another aspect of possible intensification was a photocatalyst formulation. The efficiency of photocatalytic films that consisted of pure TiO2 nanoparticles was compared to the efficiency of films that consisted of TiO2/CNT composites. Intensification assessment was performed via detailed kinetic modelling, combining the optical properties of films, irradiation conditions and reactor mass balance. Intensification was expressed via intensification indices. Results showed the advantage of the CPC-based reactor design and an unbiased effect of sensitizing agent (CNT) in the photocatalytic film formulation.

30 May 2023 in Processes
Verified
Journal Article
Open access
PDF file
AAAleksandra Anić-Vučinić
Aleksandra Anić-Vučinić
SŠSnježana Šimunić
Snježana Šimunić
LRLucija Radetic
Lucija Radetic
Ivana PreseckiIvana Presecki
Ivana Presecki
The utilization of valuable properties of waste and their reuse as raw materials is an imperative of the circular economy. Waste electrical and electronic equipment (WEEE) is a significant source of valuable raw materials, certain metals, and rare earth elements that are the basis for highly sophisticated IT equipment production. It is estimated that the production of WEEE in Europe in 2019 was 16.20 kg/inhabitant, while quantities continue to grow at a rate of 3–4% per year. Waste liquid crystal displays used in televisions, laptops, desktops, and other devices represent a significant share of WEEE and contain 0.12–0.14% of liquid crystals whose main ingredient is indium—tin oxide. In order to investigate and determine the methods and conditions of indium recycling from waste LCDs, laboratory research was conducted. The influence of temperature, particle size, and retention time in different media with and without ultrasound treatment was monitored to provide the efficiency of indium leaching. The analysis of the results showed that 98% indium leaching was achieved with granulation samples of 10 × 10 mm at a temperature 40 °C/40 min in solution H2O:HCl: HNO3 = 6:2:1 under ultrasound conditions, while aqueous and alkaline media under the same conditions did not show significant efficiency. This study can be used as a practical reference for the recycling of indium from LCD panels.

17 June 2024 in Detritus
Verified
Journal Article
Closed access
PDF file
AVAleksandra Anić Vučinić
Aleksandra Anić Vučinić
JBJosipa Bartulovic
Josipa Bartulovic
VZVlasta Zanki
Vlasta Zanki
Ivana PreseckiIvana Presecki
Ivana Presecki
The growth of solar energy has been remarkable between 2013 and 2022, with a doubling of capacity from 80 GW to 197 GW. To recover valuable materials and mitigate environmental impact, it is imperative to have effective waste management practices in place. While recycling technologies are still in the experimental phase, the EU has put in place legal frameworks for manufacturer liability. There are continuous efforts being made to develop commercially viable technologies for the management of end-of-life PV module waste. An important part of the system of renewable sources is the establishment of a high-quality and efficient waste management system, which is contained within the concept of the circular economy. PV modules will at some point reach the end of their life cycle, which is estimated to be around 25 years, and become waste, therefore a lot of effort is currently being put into research and development of different waste treatment technologies of PV modules. They are still in the experimental phase, and few technologies become commercially available. Also, the management of waste generated at the end of the life cycle of photovoltaic technology is not yet fully regulated. However, at the level of the European Union, there is a legal framework for the liability of PV module manufacturers according to Directive on electric waste and electronic equipment. This paper is a detailed review of recycling technologies based on existing literature.

18 September 2024 in Surfaces
Verified
Journal Article
Open access
PDF file
PBPaula Benjak
Paula Benjak
LRLucija Radetic
Lucija Radetic
Ivana PreseckiIvana Presecki
Ivana Presecki
IBIvan Brnardić
Ivan Brnardić
Nikola SakačNikola Sakač
Nikola Sakač
Ivana GrčićIvana Grčić
Ivana Grčić
The extensive global use of rubber results in significant microplastic pollution from the release of tire wear particles and microplastic leachate, impacting the environment, human health, and ecosystems. Waste tires are normally recycled and used for the production of new products, such as rubber tiles. The presented study aims to show the possibility of further decrease in the negative environmental impact of materials based on recycled rubber. This paper presents the modification of rubber tiles with a titanium dioxide (TiO2) coating, focusing on surface integrity, rubber particle wear release, and the consequent environmental impact of leachate release. Both reference and modified rubber tiles were subjected to artificial accelerated aging in a solar simulator for 4, 6, and 8 weeks, followed by an abrasion test. The carbonyl index was calculated from FTIR characterization after each time frame to indicate the degradation of organic compounds and chemical changes caused by UV exposure. A 24 h leaching test with a liquid-to-sample ratio of 1:20 was performed on both rubber tile samples prior to and after 8 weeks of aging along with the aged wear particles for the purpose of the non-target screening of released organic leachate by LC/MS QTOF. The results of carbonyl indices showed that the TiO2 coating contributes to the stabilization of polymer degradation and, to a certain extent, reduces the leaching of organic compounds, such as phthalates. However, the increased wear and release of rubber particles and the subsequent degradation of organic leachates require further in-depth research.

1 January 2021 in Environmental Engineering and Management Journal
Verified
Journal Article
Closed access
Ivana PreseckiIvana Presecki
Ivana Presecki
SSSnjezana Simunic
Snjezana Simunic
AVAleksandra Anic Vucinic
Aleksandra Anic Vucinic
GKGoran Kniewald
Goran Kniewald