A wide range of published scientific articles on metal content in printed circuit boards show that it is necessary to determine the content of individual metals. The aim of this paper is to show how metal content varies according to the type and age of waste electrical and electronic equipment collected in the Republic of Croatia. Samples of cell phones, TV sets, and computers are collected. The metal content is determined for electronic components and printed circuit board base plates separately for different grain sizes (1-4 mm, 0.5-1 mm, 0.1-0.5 mm and < 0.1 mm). The results show that electronic components form a larger part of printed circuit board mass fraction depending on the equipment age and type. Generally, electronic components do have a higher mass fraction for most metals (like: aluminium, copper, nickel, zinc, gold, and silver in most cases) in comparison to printed circuit board base plates, but for certain metals (like: lead, tin) the opposite applies. The electronic components of larger grain sizes (1-4 mm and 0.5-1 mm) contain more aluminium, copper, and zinc, and less lead, while the smaller grain size fractions are richer in gold. The bare boards base plates of larger grain sizes contain more copper, lead and tin, while the smallest grain size class (< 0.1 mm) contains more aluminium and gold. No clear trends are noticed in the case of silver and lead.
The growth of solar energy has been remarkable between 2013 and 2022, with a doubling of capacity from 80 GW to 197 GW. To recover valuable materials and mitigate environmental impact, it is imperative to have effective waste management practices in place. While recycling technologies are still in the experimental phase, the EU has put in place legal frameworks for manufacturer liability. There are continuous efforts being made to develop commercially viable technologies for the management of end-of-life PV module waste. An important part of the system of renewable sources is the establishment of a high-quality and efficient waste management system, which is contained within the concept of the circular economy. PV modules will at some point reach the end of their life cycle, which is estimated to be around 25 years, and become waste, therefore a lot of effort is currently being put into research and development of different waste treatment technologies of PV modules. They are still in the experimental phase, and few technologies become commercially available. Also, the management of waste generated at the end of the life cycle of photovoltaic technology is not yet fully regulated. However, at the level of the European Union, there is a legal framework for the liability of PV module manufacturers according to Directive on electric waste and electronic equipment. This paper is a detailed review of recycling technologies based on existing literature.
28 July 2016 in Waste Management & Research: The Journal for a Sustainable Circular Economy
The usage of old equipment (over 10-year-old diesel-fuelled waste collection vehicles, WCVs) for municipal solid waste (MSW) collection in Ludbreg for longer than a decade has had a negative environmental impact, which has been reduced by replacing an old diesel WCV with a new diesel WCV. This study aims to assess the share of air emissions of two old WCVs (FAP 1990 and MAN 2003) and one new (MAN 2015), expressed in CO2 emissions. In addition, these vehicles have been found easily to reach the limit of 100 dB, which can cause hearing damage in their surroundings. Furthermore, their average fuel consumption is more than 80 l per 100 km, which makes them ineffective in terms of fuel consumption. Generally, higher fuel consumption results in more emissions and for a more eco-friendly operation, the MAN 2003 from Ludbreg WCV fleet should be technically amended and adjusted, and the FAP 1990 should be retired. Although the MAN 2015 is diesel fuelled, the best solution for replacement, according to Maimoun et al. ( Waste Management 33: 1079–1089, 2016), would be the use of hydraulic-hybrid vehicles, which provide the best environmental benefits over other alternatives. According to Maimoun et al., hybrid is better environmentally, diesel is the best environmental–economical option and landfill gas-sourced natural gas is the best alternative when accessible because it significantly (up to 80%) reduces emissions of hazardous gases as well as noise levels (50–98%).