Directional strain sensing is essential for advanced sensor applications in the field of human‐machine interfaces and healthcare. Here, the angle dependent anisotropic strain sensitivity caused by charge carriers percolating through cross‐linked gold nanoparticle (GNP) networks is studied and these versatile materials are used for the fabrication of wearable triaxial pulse and gesture sensors. More specifically, the anisotropic response of 1,9‐nonanedithiol cross‐linked GNP films is separated into geometric and piezoresistive contributions by fitting the measured data with an analytic model. Hereby, piezoresistive coefficients of g11 ∼ 32 and g12 ∼ 21 are extracted, indicating a slightly anisotropic response behavior of the GNP‐based material. To use the material for healthcare applications, arrangements of three GNP transducers are patterned lithographically and fully embedded into a highly flexible silicone polymer (Dragon Skin 30). The new encapsulation method ensures good and robust electrical contacts and enables facile handling and protection from external influences. A facile read‐out with wireless data transmission using off‐the‐shelf electrical components underlines the great potential of these devices for applications as skin‐wearable healthcare sensors.
Wearable flexible strain sensors with spatial resolution enable the acquisition and analysis of complex actions for noninvasive personalized healthcare applications. To provide secure contact with skin and to avoid environmental pollution after usage, sensors with biocompatibility and biodegradability are highly desirable. Herein, wearable flexible strain sensors composed of crosslinked gold nanoparticle (GNP) thin films as the active conductive layer and transparent biodegradable polyurethane (PU) films as the flexible substrate are developed. The patterned GNP films (micrometer‐ to millimeter‐scale square and rectangle geometry, alphabetic characters, and wave and array patterns) are transferred onto the biodegradable PU film via a facile, clean, rapid and high‐precision contact printing method, without the need of a sacrificial polymer carrier or organic solvents. The GNP‐PU strain sensor with low Young's modulus (≈17.8 MPa) and high stretchability showed good stability and durability (10 000 cycles) as well as degradability (42% weight loss after 17 days at 74 °C in water). The GNP‐PU strain sensor arrays with spatiotemporal strain resolution are applied as wearable eco‐friendly electronics for monitoring subtle physiological signals (e.g., mapping of arterial lines and sensing pulse waveforms) and large‐strain actions (e.g., finger bending).
This study presents a method for printing flexible chemiresistors comprising thin film transducers based on cross-linked gold nanoparticles (GNPs). First, interdigitated silver paste electrodes are printed onto polyimide (PI) foil via dispenser printing. Second, coatings of GNPs and dithiol/monothiol blends are inkjet-printed onto these electrode structures. 1,9-Nonanedithiol (9DT) is used as cross-linking agent and a variety of monothiols are added to tune the sensors’ chemical selectivity. When dosing these sensors with different analyte vapors (n-octane, toluene, 4-methyl-2-pentanone, 1-butanol, 1-propanol, ethanol, water; concentration range: 25–2000 ppm) they show fully reversible responses with short response and recovery times. The response isotherms follow a first-order Langmuir model, and their initial slopes reveal sensitivities of up to 4.5 ppm−1. Finally, it is demonstrated that arrays of printed sensors can be used to clearly discern analytes of different polarity.