Abhishek Sen

Dr. Abhishek Sen

orcid

Research Focus & Metrics

Academic Career Length

33Years (1994-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 1994 in Journal of Materials Science Letters
Verified
Journal Article
Closed access
PDF file
DSD. Saha
D. Saha
ASAbhishek Sen
Abhishek Sen
HMH. S. Maiti
H. S. Maiti

23 June 2021 in Applied Sciences
Verified
Journal Article
Open access
PDF file
PGPartha Sarathi Ghosh
Partha Sarathi Ghosh
ASAbhishek Sen
Abhishek Sen
Somnath ChattopadhyayaSomnath Chattopadhyaya
Somnath Chattopadhyaya
SSSHUBHAM SHARMA
SHUBHAM SHARMA
JSJujhar Singh
Jujhar Singh
KGKhaled Giasin
Khaled Giasin
Distribution of temperature during the welding process is essential for predicting and realizing some important welding features such as microstructure of the welds, heat-affected zone (HAZ), residual stresses, and their effects. In this paper, a numerical model was developed using COMSOL Multiphysics of dissimilar laser welding (butt joint) of AISI 316L and Ti6Al4V thin sheet of 2.5 mm thickness. A continuous mode (CW) fiber laser heat source of 300 W laser power was used for the present study. A time-dependent prediction of temperature distributions was attempted. The heat source was assumed as a Hermit–Gaussian analytical function with a moving velocity of 120 mm/min. Both convective and radiant heat loss and phase change of the materials were considered for the analysis. In addition, variation of temperature-dependent material properties was also considered. The maximum and minimum temperature for the two materials at different times and the temperature in the different penetration depths were also predicted. It was found that the average temperature that can be achieved in the bottom-most surface near the weld line was more than 2400 K, which justifies the penetration. Averages of maximum temperatures on the weld line at different times at the laser spot irradiation were identified near 3000 K.The temperature fluctuation near the weld line was minimal and decreased more in the traverse direction. Scanning with a displaced laser relative to the interface toward the Ti6Al4V side reduces the maximum temperature at the interface and the HAZ of the 316L side. All of these predictions agree well with the experimental results reported in current literature studies.

1 January 2009 in Journal of Membrane Science
Verified
Journal Article
Closed access
APA. Prakash
A. Prakash
SMS. Majumdar
S. Majumdar
PDP. Sujatha Devi
P. Sujatha Devi
ASAbhishek Sen
Abhishek Sen

17 May 2023
Verified
Book Chapter
Closed access
PDF file
ABA. R. Biswas
A. R. Biswas
NBN. Banerjee
N. Banerjee
ASAbhishek Sen
Abhishek Sen
SMSaikat Ranjan Maity
Saikat Ranjan Maity

9 April 2015
Verified
Book Chapter
Closed access
PDF file
ASAbhishek Sen
Abhishek Sen
BDB. Doloi
B. Doloi
BBB. Bhattacharyya
B. Bhattacharyya

25 July 2020 in Journal of the Brazilian Society of Mechanical Sciences and Engineering
Verified
Journal Article
Closed access
PDF file
ASAbhishek Sen
Abhishek Sen
BDB. Doloi
B. Doloi
BBB. Bhattacharyya
B. Bhattacharyya