Fibre-reinforced polymer (FRP) rebar and geopolymer concrete (GPC) are relatively new construction materials that are now been increasingly used in the construction sectors. Both materials exhibit superior structural and durability properties that also make them a sustainable alternative solution. Due to the absence of any design standard for an FRP-reinforced GPC beam, it is important to validate the efficacy of available standards and literature related to other materials, e.g., FRP-reinforced conventional concrete or GPC alone. Four theories/design standards are considered for this comparison—ACI440.1R-15, CAN/CSA S806-12, parabolic stress block theory, and equivalent rectangular stress block theory for GPC under compression. The accuracy of these four approaches is also examined by studying the flexural performance of both the glass FRP (GFRP) and carbon FRP (CFRP). The FRP-reinforced beams are designed against the actual load they will be subjected to in a real-world scenario. It is concluded that parabolic stress block theory over-estimates the capacity, whereas CSA S806-12 yields the most accurate and conservative results. In addition, the flexural performance of the FRP-reinforced beams is evaluated in terms of ultimate, cracking, and service moment capacity, along with serviceable, ultimate, and residual deflection.

The mechanical properties of the structural components (i.e., columns and beams produced from engineered bamboo products), such as, bamboo scrimber (also known as parallel bamboo strand lumber, PBSL) and Laminated Bamboo Lumber (LBL), have attracted considerable attention from researchers in recent years. In previous studies, researchers reported on the stress-strain behaviour of bamboo scrimber, LBL and glue laminated bamboo under compression and proposed some empirical and semi-empirical models, based on their individual studies. However, a generic constitutive model for engineered bamboo products is still not available. The compressive stress-strain curves of bamboo scrimber and LBL are reported to show a similar behaviour with three distinct stages i.e., a linear elastic stage followed by a nonlinear plastic stage and a plateau. As part of the current study, the previously proposed models for bamboo scrimber were carefully studied and all available material test results on engineered bamboo were used to develop a generic constitutive model, based on the Ramberg-Osgood (RO) formulation considering its suitability to capture its material nonlinearity. Based on the test results, it was observed that 1% proof stress can be used in a compound RO model to predict an accurate material response for bamboo scrimber. The proposed modelling technique has also been applied to predict the compressive behaviour of LBL. This paper proposes the RO coefficients for both bamboo scrimber and LBL that can be used to develop accurate nonlinear models for engineered bamboo products.