This paper proposes an energy-saving system based on a prefill system and a buffer system to improve the energy efficiency and the processing performance of hydraulic presses. Saving energy by integrating such systems into the cooling system of a hydraulic press has not been previously reported. A prefill system, powered by the power unit of the cooling system, is used to supply power simultaneously with the traditional power unit during the pressurization stage, thus reducing the usage of pumps and installed power of the hydraulic press. In contrast to the traditional prefill system, the proposed energy-saving system is controlled by a servo valve to adjust flow according to the load profile. In addition, a buffer system is employed to the cooling system to absorb the hydraulic shock generated at the unloading stage, store those shares of hydraulic energy as a recovery accumulator, and then release this energy to power the prefill system and the hydraulic actuator in the subsequent productive process. Finally, through a series of comparative experiments, it was preliminarily validated that the proposed system could reduce the installed power and pressure shock by up to 22.85% and 41%, respectively, increase energy efficiency by up to 26.71%, and provide the same processing characteristics and properties as the traditional hydraulic press.
This paper proposes an electro-hydraulic servo control method and realizes the automatic control and remote control of free forging hammers for the first time. A configuration and control strategy for the program-control free forging hammer are constructed. Based on the configuration, a single-acting differential servo cylinder system is proposed to drive the follow-up spool valve and then control the motion state of the hammerhead. Furthermore, a non-contact measurement method is adopted to detect the real-time position of the hammerhead, and the installation position of the measuring sensor is isolated from the hammer body and foundation, thereby reducing the influence of vibration and impact on the accuracy of the feedback signal and ensuring the successive forming process of the forging hammer. In addition, a blow energy model of the forging hammer processing system is established, and a fuzzy-PID control scheme for the forging hammer is then adopted. Based on the control strategy, the striking accuracy of the proposed automatic forging hammer is significantly improved compared with the traditional forging hammer. Finally, the method is applied to an 8 MN forging hammer, and the results show its better processing performance than traditional hammers in terms of all indices.
9 February 2023 in International Journal of Energy Research
Each part of a hydraulic press dissipates a large amount of energy when energy or power is transmitted. Therefore, this study proposes a 3-D vertical arrangement structure for the hydraulic press to reduce their energy dissipation. In the proposed structure, the aboveground and underground spaces are comprehensively utilized, and then the hydraulic equipment are arranged three-dimensionally and set in layers according to the functional requirements. Some equipment is connected directly to minimize the use of valves and pipelines and reduce the transmission distance of hydraulic energy between the pump station and the actuator. Furthermore, a method for scheduling the drive system in the above structure is presented to share a transmission zone with no conflict and shorten their idle time. The composition of each zone is set to match the power demand of each operation to achieve the scheduling schemes. Finally, the proposed scheme is applied to a 31.5 MN hydraulic press as a case study. Results showed that the energy efficiency increased from 43.95% to 85.03%, demonstrating excellent energy-saving potential.