A Microbial Fuel Cell (MFC) is a process in which a microorganism respires and captures the electrons that normally passes through the electron transport system of the organism and produces electricity. This work intends to present the different operating parameters affecting the efficiency of a Microbial Fuel Cell (MFC) process. To study the performance of the process, various materials for the cathode and anode rods with similar size and chape including, copper, aluminum, carbon cloth, steel and brass were considered to determine the combination that leads to the best results. Moreover, different oxidizing agents such as Copper Sulphate and Potassium Hexacyanoferrate were considered. Furthermore, the effects of shapes, sizes and distance between electrodes on the current and voltage were investigated. The power outputs between electrochemical and microbial cells were recorded. In addition, the power, whether expressed as voltage or current, was measured at different conditions and different cell combinations. The power is directly related to the area, volume of the bacterial solution and supplying air and stirring.
Wastewater treatment plants (WWTPs) are one of the most energy-intensive industries. Every stage of wastewater treatment consumes energy, which is the primary contributor to WWTP costs. Adsorbents and process optimization are critical for energy savings. The removal of dyes from industrial wastewater by adsorption using commercially available adsorbents is inefficient. Metal–organic frameworks (MOFs) have outstanding properties that can improve separation performance over current commercial adsorbents, and thus, these materials represent a milestone in improving dye removal in water treatment methods. In this work, three types of metal–organic frameworks (Fe-BTC, Cu-BTC, and ZIF-8) have been investigated as prospective adsorbents for methyl orange removal from water in batch setups. The results showed that at 15 mg/L MO initial concentration and 100 mg dosage, Fe-BTC had the highest removal efficiency of 91%, followed by ZIF-8 (63%), and finally Cu-BTC (35%), which exhibited structural damage due to its instability in water. Fe-BTC maintained consistent adsorption capacity over a wide range of pH values. Furthermore, a 23 full factorial design analysis was implemented to evaluate the conditions for maximum MO-removal efficiency. The main effects, interaction effects, analysis of variance (ANOVA), and the Pareto chart were reported. The statistical analysis demonstrated that the MOF type was the most significant factor, followed by dosage and initial concentration. The analysis indicated that the type of MOF and dosage had a positive effect on the removal efficiency, while the initial concentration had a negative effect. The two-way and three-way interactions were also found to be significant.
1 October 2014 in Advanced Science, Engineering and Medicine
This study presents a sustainable and time-efficient method for producing aerated lightweight concrete (ALC) by addressing two key challenges: long drying times and limited high-silica sand. The proposed approach combines rapid drying, reducing curing time from 24–48 h to less than one hour, with recycled glass powder to enrich locally available silica-poor sand. The concrete mixtures were characterized using scanning electron microscopy (SEM) and energy-dispersive spectroscopy (EDS), along with experimentally determined key parameters such as compressive strength, dry density, porosity, and thermal conductivity. Comparative testing was conducted using sand samples from the UAE and UK to represent contrasting climatic and geological conditions, silica-poor desert versus silica-rich quartz, to evaluate adaptability and performance. Two mixes were tested: untreated and glass enriched. The modified mix achieved higher compressive strength, better thermal insulation, and lower environmental impact, while rapid drying maintained structural integrity. The method offers a scalable, low-carbon solution aligned with circular economic principles.