Research on the coupling of membrane separation (MS) and electrochemical advanced oxidation processes (EAOPs) has been a hot area in water pollution control for decades. This coupling aims to greatly improve water quality and focuses on the challenges in practical application to provide a promising solution to water shortage problems. This article provides a summary of the coupling configurations of MS and EAOPs, including two-stage and one-pot processes. The two-stage process is a combination of MS and EAOPs where one process acts as a pretreatment for the other. Membrane fouling is reduced when setting EAOPs before MS, while mass transfer is promoted when placing EAOPs after MS. A one-pot process is a kind of integration of two technologies. The anode or cathode of the EAOPs is fabricated from porous materials to function as a membrane electrode; thus, pollutants are concurrently separated and degraded. The advantages of enhanced mass transfer and the enlarged electroactive area suggest that this process has excellent performance at a low current input, leading to much lower energy consumption. The reported conclusions illustrate that the coupling of MS and EAOPs is highly applicable and may be widely employed in wastewater treatment in the future.
Membrane fouling and regeneration are the key issues for the application of membrane separation (MS) technology. Reactive electrochemical membranes (REMs) exhibited high, stable permeate flux and the function of chemical-free electrochemical regeneration. This study fabricated a micro-filtration REM characterized by a PbO2 layer (PbO2-REM) to investigate the electro-triggered anti-fouling and regeneration progress within REMs. The PbO2-REM exhibited a three-dimensional porous structure with a few branch-like micro-pores. The PbO2-REM could alleviate Humic acid (HA) and Bisphenol A (BPA) fouling through electrochemical degradation combined with bubble migration, which achieved the best anti-fouling performance at current density of 4 mA cm−2 with 99.2% BPA removal. Regeneration in the electro-backwash (e-BW) mode was found as eight times that in the forward wash and full flux recovery was achieved at a current density of 3 mA cm−2. EIS and simulation study also confirmed complete regeneration by e-BW, which was ascribed to the air–water wash formed by bubble migration and flow. Repeated regeneration tests showed that PbO2-REM was stable for more than five cycles, indicating its high durability for practical uses. Mechanism analysis assisted by finite element simulation illustrated that the high catalytic PbO2 layer plays an important role in antifouling and regeneration.
With the growing demand for high-quality discharge, reverse osmosis (RO) technology has been widely applied in landfill leachate treatment; however, the problem of reverse osmosis concentrates (ROCs) has worsened. In this work, a Ti4O7-nanotube reactive electrochemical membrane (Ti4O7-NT-REM) was employed to treat ROCs from landfill leachate treatment. The effects of current density, flow rate and pH on COD removal were evaluated, and the appropriate conditions were a current density of 20 mA cm−2, a flow rate of 10 mL s−1 and a pH of 7. Under these conditions, COD, TOC, NH4+-N and NO3−-N were removed by 82%, 68%, 100% and 73%, respectively. In addition, the 3D-EEM fluorescence spectra and GC–MS results revealed that the organics significantly decreased after 120 min of treatment, and aliphatic compounds were the major organic compounds. The stable performance of the REM was illustrated by cyclic treatment (20 cycles) with the assistance of cathodic polarization. In addition, a long service lifetime of 267.3 h and a low energy consumption of 7.6 kWh·kg COD−1 were obtained by related testing and evaluation. The excellent and stable performance confirmed that the Ti4O7-NT-REM has broad application prospects in the treatment of ROCs.
4 January 2023 in Frontiers in Bioengineering and Biotechnology