The paper is focused on the examination of the internal quality of joints created in a multi-material additive manufacturing process. The main part of the work focuses on experimental production and non-destructive testing of restrained joints of modified PLA (polylactic acid) and ABS (Acrylonitrile butadiene styrene) three-dimensional (3D)-printed on RepRap 3D device that works on the “open source” principle. The article presents the outcomes of a non-destructive materials test in the form of the data from the Laser Amplified Ultrasonography, microscopic observations of the joints area and tensile tests of the specially designed samples. The samples with designed joints were additively manufactured of two materials: Specially blended PLA (Market name—PLA Tough) and conventionally made ABS. The tests are mainly focused on the determination of the quality of material connection in the joints area. Based on the results obtained, the samples made of two materials were compared in the end to establish which produced material joint is stronger and have a lower amount of defects.
During the operation of engineering structures made of natural stone, for industrial and civil purposes, an important parameter in monitoring their technical condition is the assessment of their reliability and safety under the influence of various external influences. In this case, high-quality monitoring of the stress–strain state of natural stone structures, its physical, mechanical and filtration properties, as well as internal structural features is necessary to study the possibility of replacing individual elements of objects that have lost their original characteristics. To assess the state of geomaterials, this article proposes using a complex of introscopic methods, including infrared radiometry and laser-ultrasound structuroscopy. An important aspect is the calculation based on the Green–Christoffel equation of the velocity of a quasi-longitudinal wave in limestone consisting of densely packed, chaotically oriented calcite grains with a small quartz content. For the first time, using laser-ultrasonic structuroscopy and standard methods for determining open porosity, both total and closed porosity were determined. This allowed us to find the values of specific heat capacities of dry and water-saturated samples. The obtained values are used to find the ratio of changes in the temperature of dry and water-saturated samples at the same stress values. The results obtained demonstrate the need to take into account changes in the intensity of thermal radiation of limestone with different moisture content under conditions of uniaxial compression, when identifying changes in the stress state of elements of stone structures in real conditions.
Vehicle mobility is an increasingly important issue today, even in the military field. Mobility depends on the condition of the vehicle, the route and, of course, the experience of the driver. Vehicle failures and damage are very common in military operations. It is therefore important to find out how these failures and damage can affect mobility. One of the essential parts of a vehicle is the braking system. The authors therefore decided to investigate what is the effect of a malfunctioning brake system on emergency braking behaviour of a special vehicle in a curvilinear movement. Simulation tests were performed based on an experimentally validated model. The tests were performed with a wheeled vehicle on three different surfaces: concrete, wet asphalt, and ice. The experimental conditions were given as follows – the braking process was considered for a braking system with ABS on and off and for two states of braking system sufficiency (8 braked wheels or 4 rear braked wheels). These tests allowed us to analyse the effect of the extent of the damage on safety, in this case the stopping of the vehicle on a specified curved route. The results of braking and stability on different surfaces and under given conditions are evaluated and described in this paper. On the basis of the results, it is possible to prepare training programmes (scenarios) for drivers of special vehicles for the purpose of driving techniques in critical situations.
1 January 2014 in International Journal of Building Sustainability and Secure