Pneumatic systems use the energy of compressed air to carry out manufacturing automation processes through the implementation of complex handling and motion tasks. However, these systems are energy intensive: it is estimated that pneumatic systems in manufacturing plants consume approximately 10% of all electricity consumed in the industrial sector. At the same time, the energy efficiency of the whole pneumatic system is observed to be 6–10%, due to the compression process, oversizing, and overconsumption. There are numerous solutions in the literature focusing on improving efficiency at the compression stage of utilization; however, for the utilization stage, there is a lack of systematization and grouping of these solutions. The following review will summarize current knowledge about the utilization stage and methods for improving oversizing and energy overconsumption. In addition, a method of exergy analysis for pneumatic systems will be presented, which is a very useful tool to assess the efficiency of these systems.

By choosing parameters of production process of magnetic powder core (MPC), it is possible to develop magnetic properties of cores and match them to specific application. This paper shows how the size of granular material can impact the magnetic characteristics of powder cores. Particular attention is paid to high frequency inductance elements, made of nanocrystalline powder, like inductors, chokes and transformers. Advantages of this components are: stable relative permeability pr, low specific power loss P, and possibility to develop a wide range of other magnetic parameters.

As global energy demand continues to rise, integrating renewable energy sources (RES) into power systems has become increasingly important. However, the intermittent nature of RES, such as solar and wind, presents challenges for maintaining a stable energy supply. To address this issue, energy storage systems are essential. One promising technology is micro-compressed air energy storage (micro-CAES), which stores excess energy as compressed air and releases it when needed to balance supply and demand. This study investigates the integration of micro-CAES with RES in a 19-home microgrid in northern Portugal. The research aims to evaluate the effectiveness of a microgrid configuration that includes 100 kW of solar PV, 70 kW of wind power, and a 50 kWh micro-CAES system. Using real-world data on electricity consumption and local renewable potential, a simulation is conducted to assess the performance of this system. The findings reveal that this configuration can supply up to 68.8% of the annual energy demand, significantly reducing reliance on the external grid and enhancing the system’s resilience. These results highlight the potential of micro-CAES to improve the efficiency and sustainability of small-scale renewable energy systems, demonstrating its value as a key component in future energy solutions.

In this paper, we demonstrate how to reduce the noise level of expanded air from pneumatic tools. Instead of a muffler, we propose the expanded collecting system, where the air expands through the pneumatic tube and expansion collector. We have elaborated a mathematical model which illustrates the dynamics of the air flow, as well as the acoustic pressure at the end of the tube. The computational results were compared with experimental data to check the air dynamics and sound pressure. Moreover, the study presents the methodology of noise measurement generated in a pneumatic screwdriver in a quiet back room and on a window-fitting stand in a production hall. In addition, we have performed noise measurements for the pneumatic screwdriver and the pneumatic screwdriver on an industrial scale. These measurements prove the noise reduction of the pneumatic tools when the expanded collecting system is used. When the expanded collecting system was applied to the screwdriver, the measured Sound Pressure Level (SPL) decreased from 87 to 80 dB(A).