19 January 2010 in IEEE Transactions on Magnetics
One of the most important parameters of electrical steel sheet is specific total loss. In order to analyze the specific total loss, seven electrical steel grades were separated into three components: the hysteresis loss component and both the classical and additional eddy current loss components. Parameters used for the description of loss components in statistical loss models were analyzed and found to be dependent on electrical steel grade, and hence, on grain orientation. The aim of this paper is to provide a contribution to the better understanding of magnetic specific total loss in electrical steel sheets.
16 December 2008 in IEEE Transactions on Magnetics
The aim of this paper is to compare the properties of cores designed for medium voltage current transformers. The cores were made of SiFe, NiFe polycrystalline strips, and nanocrystalline strips. The properties of cores combined of two different soft magnetic materials, i.e., grain-oriented electrical steel SiFe and NiFe polycrystalline strip (SiFe+NiFe) or grain-oriented electrical steel and Fe-based nanocrystalline strip (SiFe+Nano) also have been determined. The content of harmonic distortions in a magnetizing current in various combinations of toroidal cores is presented. The lowest harmonic distortions occur in cores with grain-oriented electrical steel SiFe and the largest - in cores with NiFe polycrystalline strips among all the tested magnetic circuits. Taking into consideration magnetic properties, the best solution is the SiFe+Nano combined cores this is because of the content of harmonic distortions in comparison to SiFe+NiFe and high values of relative magnetic permeability and the shape of the magnetization curve supporting the use of SiFe+Nano in instrument transformers.
1 February 2017 in Measurement
17 May 2018 in Physica B: Condensed Matter
30 October 2015 in IEEE Transactions on Magnetics
Electrical steel (ES) plays an important role in the design of magnetic circuit cores of electrical machines. Separating specific total loss into components is an excellent tool for loss analysis in ES. As is commonly accepted, the specific total loss is separated into three components: hysteresis and both classical and additional eddy current loss components. In addition, the conventional grain-oriented (GO) ES presents the strong anisotropy of magnetic properties, due to the (110) [001] Goss texture, with [001] the easiest direction [parallel to rolling direction (RD)], with intermediate [011] and magnetically worst [111] directions, at angles x = 0°, 90°, and about 54° to RD, respectively. However, magnetization angles 0° <; x <; 54° and 54° <; x <; 90° also play a very important role in the research of specific total loss components. The angular properties of specific total loss under axial magnetization in GO ES should be most preferably evaluated by the use of single-sheet tester with specimens cut at different angles with respect to RD. This paper demonstrates, in the quantitative way, the dependence of hysteresis P h and additional eddy current Pa specific total loss components on Goss texture. In addition, the results obtained justify the division of specific total loss and its components in two flux density regions: below B m ≤ 1 T (the lower region) and above B m > 1 T (the upper region). This paper is intended to offer a better understanding of phenomena that cause magnetic anisotropy, i.e., different Goss textures.