The direct hydrogenation of CO2 into methanol is crucial for providing a means of CO2 fixation and a way to store cleanly produced hydrogen in a more energy-dense and transportable form. Here we have prepared two series of Pd/ZnO catalysts, both by immobilisation of PVA-protected Pd colloids and by Pd impregnation of PdCl2 to investigate structure activity relationships for direct CO2 hydrogenation. Very different performances were found for the different preparation methods, and the Pd loading and pre-reduction of the catalysts were shown to be important factors for optimising methanol yield. The crucial factor for high methanol yield is the formation of a Pd–Zn alloy, either during the reaction itself, or better by high temperature pre-reduction. The formation of the alloy greatly reduces CO production by the reverse water gas shift reaction. The catalysts prepared by sol-immobilisation were relatively stable to thermal treatment. In contrast, the impregnated catalysts were much less thermally stable, due to the presence of remnant chloride on the surface of the catalyst, which was absent for the case of sol immobilisation preparation. The results illustrate the importance of controlling the PdZn particle size and its surface structure for the catalysts to achieve high methanol selectivity (60%, the rest being CO) and conversion (11%) at 250°C and 20bar. Selectivity for sol-immobilised catalysts decreases from 60% at 3nm average diameter, to 20% at 7nm
The carbon–carbon coupling via electrochemical reduction of carbon dioxide represents the biggest challenge for using this route as platform for chemicals synthesis. Here we show that nanostructured iron (III) oxyhydroxide on nitrogen-doped carbon enables high Faraday efficiency (97.4%) and selectivity to acetic acid (61%) at very-low potential (−0.5 V vs silver/silver chloride). Using a combination of electron microscopy, operando X-ray spectroscopy techniques and density functional theory simulations, we correlate the activity to acetic acid at this potential to the formation of nitrogen-coordinated iron (II) sites as single atoms or polyatomic species at the interface between iron oxyhydroxide and the nitrogen-doped carbon. The evolution of hydrogen is correlated to the formation of metallic iron and observed as dominant reaction path over iron oxyhydroxide on oxygen-doped carbon in the overall range of negative potential investigated, whereas over iron oxyhydroxide on nitrogen-doped carbon it becomes important only at more negative potentials.
Rational design of low-cost and active electrocatalysts is crucial for upgrading of biomass-derived chemicals. Here, we report highly efficient catalysts ternary NiCoMn-layered double hydroxides (NiCoMn-LDHs) nanosheets which are oxygen vacancy-rich, produced under controllable conditions for the electrooxidation of both 5-hydroxymethylfurfural (HMF) to 2,5-furandicarboxylic acid (FDCA) and furfural to furoic acid (FurAc) under mild conditions, respectively. Electrochemical tests showed that the oxidation of HMF and furfural occurred prior to the oxidation of water at lower applied potentials with NiCoMn-LDHs catalysts. High yields of FDCA (91.7%) and FurAc (92.4%) were achieved in 2.5 h using 1.15 nm thick NiCoMn-LDHs nanosheets under the optimal conditions. The mechanism for the superior performance, high durability, and good faradaic efficiency has been elucidated by comprehensive characterization, which confirmed that ultrathin nanosheets expose more Co-NiOOH active sites with oxygen vacancies, facilitating the synergistic effect between HMF and furfural oxidation reaction on Co–Ni and Mn2+ states. The oxygen vacancy-rich NiCoMn-LDHs nanosheet catalysts present a novel and energy-efficient solution to obtain upgraded biochemicals.