The inclusion of the MgO·Al2O3 (MA) spinel and CaO–Al2O3 are occasionally observed during the refining of Al–killed steel, even without the intentional additions of Ca and Mg. Many studies have focused on the source of Mg and Ca; however, especially for the formation of CaO–Al2O3–type inclusions, some recent results showed that Ca was difficult to dissolve from refining slag, even when the Al content in molten steel was high. To confirm these differences, industrial experiments were designed in this study, and the effects of the FeO and MnO contents, as well as the impurities of the alloying materials, were discussed. The results showed that, when the FeO and MnO contents in slag were high (about 10 mass%) at the start of LF (ladle furnace), all inclusions remained as Al2O3, despite alloying. Using the slag with low FeO + MnO content (<1~2 mass%), the Al2O3 inclusions changed to the MA spinel, but CaO–Al2O3 inclusions were not observed, indicating that CaO–Al2O3 inclusions were difficult to form by the steel/slag reactions under the current conditions. Only for the molten steel that contained a low level of dissolved oxygen and a large amount of Fe–Si, which contained Ca as the impurity was added, CaO–Al2O3 inclusions were generated.
Evolutions of two typical types of nonmetallic inclusions, i.e., inclusions based on CaO-SiO2-Al2O3 and MnO-SiO2-Al2O3 of 304 stainless steel were investigated in laboratory-scale experiments under isothermal heat treatment at 1250 °C for 0, 30, 60 and 120 min. Results show inclusion population density increases at the first stage and then decreases while their average size decreases and then increases. Moreover, almost no Cr2O3 content within the inclusion before the heat treatment, but Cr2O3 content increases gradually along with increasing heat treatment time. Furthermore, the increasing of Cr2O3 content in the inclusions would increase their melting points and reduce their plasticities. The experimental results and thermodynamic analysis indicate that there are three steps for inclusion evolution during the heat treatment process, in which Ostwald ripening plays an important role in inclusion evolution, i.e., inclusions grow by absorbing the newly formed small-size MnO-Cr2O3 inclusions.