Optics InfoBase is the Optical Society's online library for flagship journals, partnered and copublished journals, and recent proceedings from OSA conferences.
This study examines the surface-assisted photoalignment effect of dye-doped liquid-crystal films having a homogeneous alignment. Observations made using a polarizing optical microscope, a scanning electronic microscope, and an atomic force microscope confirm that the morphology of laser-induced surface-adsorbed dyes at the command surface strongly affects the orientation of liquid crystals (LC’s) in a manner that depends significantly on the intensity and duration of the pumping. In weak-intensity regime, a homogeneous and fine layer of adsorbed dyes competes with a layer of ripple structure in reorienting LC’s. These two effects dominantly cause LC’s to reorient perpendicular and parallel to the polarization direction of the pump beam in the early and late stages, respectively. In the high-intensity regime, rough and inhomogeneous ribbonlike adsorbents produced by rapid and random aggregation and adsorption form on the top of the preformed microgrooves, reorienting LC’s irregularly. This surface morphology does not enable photoalignment.
This work demonstrates a reflective Fresnel zone plate based on dye-doped cholesteric liquid crystals (DDCLC) using the photo-induced realignment technique. Illumination of a DDCLC film with a laser beam through a Fresnel-zone-plate mask yields a reflective lens with binary-amplitude structures - planar and focal conic textures, which reflect and scatter probed light, respectively. The formed lens persists without any external disturbance, and its focusing efficiency, analyzed using circularly polarized light, is ~ 23.7%, which almost equals the measured diffraction efficiency of the used Fresnel-zone-plate mask (~ 25.6%). The lens is thermally erasable, rewritable and switchable between focusing and defocusing states, upon application of a voltage.
This work proposes an optically controllable beam-steering device, fabricated using cholesteric liquid crystals (CLCs) that are doped with azobenzene. The trans-cis photoisomerization of azobenzene changes the pitch of the CLC fingerprint structure and shifts the diffraction angle. The diffraction angle increases when the cell is irradiated with UV light, and restored when it is irradiated with green light. Combining the photoisomerization effect with electrical effect, the CLC beam-steering device provides a steering angle of ~19°.The tuning is continuous and could be completed within a few seconds.
This work proposes two mechanisms for switching the direction of stripes in cholesteric liquid crystal (CLC) gratings. The stripe direction depends on the ratio of cell gap to the natural pitch length (d/P0) of a CLC sample. Electrical switching is based on the different pitches at the planar and the transient planar states. Optical switching, however, changes pitch by using the photo-isomerization effect of the azobenzene doped in a CLC sample. Using the two mechanisms, we can switch the stripe directions in two orthogonal directions. Furthermore, the beam-steering capability of CLC gratings also remains effective after switching directions.
The dynamic behavior of a holographic grating induced in a homeotropically aligned dye-doped liquid-crystal film is investigated. In the presence of an applied dc voltage, photoexcited azo dyes induce a photorefractive grating and then diffuse and are adsorbed onto cell substrates. The reorientation of liquid crystals as a result of adsorbed dyes leads to a phase grating that is phase shifted 90° from the photorefractive grating. Competition of these two gratings induces two-beam coupling of the writing beams, initially transferring energy from beam 1 to beam 2 and then, after a pause, from beam 2 to beam 1.