This paper considers a fundamental issue of path loss (PL) modeling in urban micro cell (UMi) environments, namely the spatial consistency of the model as the mobile station moves along a trajectory through street canyons. This paper is motivated by the observed non-stationarity of the PL. We show that the traditional model of power law PL plus log-normally distributed variations can provide misleading results that can have serious implications for system simulations. Rather, the PL parameters have to be modeled as random variables that change from street to street and also as a function of the street orientation. Variations of the PL, taken over the ensemble of the whole cell (or multiple cells), thus consist of the compound effect of these PL parameter variations together with the traditional shadowing variations along the trajectory of movement. Ray-tracing results demonstrate that ignoring this effect can lead to a severe overestimation of the local standard deviation in a given area. Then, a spatially consistent stochastic street-by-street PL model is established, and a parameterization for 28-GHz UMi cells is given. The model correctly describes the PL as a function of the street orientation as well as the large variance observed for all the PL model parameters.
31 March 2009 in IEEE Transactions on Antennas and Propagation
A hologram-based compact antenna test range (CATR) is designed, constructed, and used to test a 1.5-m antenna at 650 GHz. The CATR is based on a 3.16-m-diameter hologram as the collimating element. So far, this is the highest frequency at which any CATR has been used for antenna tests. The quiet zone is measured and optimized before the antenna tests. The measured antenna pattern results at 650 GHz are analyzed and compared to the simulated patterns. Feed scanning antenna pattern comparison technique is used to correct the antenna pattern. These tests show the hologram CATR to be promising for antenna measurements up to 650 GHz.
3 September 2018 in IEEE Antennas and Wireless Propagation Letters
A millimeter-wave communication system needs a directive beam-steering antenna with a low scan loss to compensate the high free space loss. In this letter, an electronically beam-switching integrated lens antenna (ILA) system with low scan loss is designed for lower E-band (71-76 GHz). An ILA with hemispherical collimating surface of 26 mm radius and spherical feed surface of 37.5 mm radius is fabricated from Teflon material. A conformal 1 × 16 linear beam-switching feed array based on SP4T switches and Vivaldi antennas is designed. The maximum simulated and measured realized gain including the switch network losses is 21.8 and 19.6 dBi, respectively. The measured scan loss of the ILA excluding the switch network loss is less than 1.3 dB in the lower E-band for beams within $\pm$ 40°.
6 January 2020 in IEEE Transactions on Vehicular Technology
The communications between two driving vehicles along a narrow street may be limited by the presence of a third vehicle blocking the transmission. In this work, we investigate radio wave propagation at 28 GHz in an urban street canyon scenario by conducting channel measurements, where the vehicle(s) occlude(s) the line-of-sight path. We quantify the impact of the car blockage and study the alternative propagation paths, which can be used for establishing a data link. Based on the obtained results, we report that besides the low-loss (3.4 dB) reflection from the wall, a radio link through the blocking car may potentially be established for data sharing. Specifically, the attenuation through clear windows is 2 dB, while the attenuation caused by protective sun film is 15 dB. Diffraction over the car and propagation in foliage reduce the multipath power crucially by 21-24 dB and 16-19 dB, respectively, and cannot be associated with reliable links. Finally, measurement results were compared with the ray-based simulation data, which demonstrates agreement to within +/- 4.3 dB of measured losses.
29 November 2016 in IEEE Wireless Communications Letters
In wireless channel measurements, the relatively weak cross-polarized multipath components (MPCs) are typically severely affected by the measurement noise level. As shown in this letter, the typical cross-polarization ratio (XPR) model parameter estimation, which ignores the existence of censored samples, may lead to significant errors. We demonstrate how to achieve accurate parameter estimates with a maximum likelihood estimator that properly takes into account both the measured XPRs and the censored samples. Also, a new XPR model is presented in which the average XPR is modeled as a function of the MPC excess loss. The new model is shown to be insensitive to the channel measurement noise level. A practical example with measured data in an indoor environment at 60 GHz demonstrates the utility of the approach.
A brief review of antenna test methods at THz frequencies is presented. Two hologram-based compact antenna test ranges (CATR), one at 322 GHz and another at 650 GHz were designed, constructed, and used for testing the ADMIRALS RTO antenna of 1.5 m in diameter. These CATRs are based on 3-meter diameter computer-generated amplitude holograms.