In case of a seismic event, a fast and draft damage map of the hit urban areas can be very useful, in particular when the epicentre of the earthquake is located in remote regions, or the main communication systems are damaged. Our aim is to analyse the capability of remote sensing techniques for damage detection in urban areas and to explore the combined use of radar (SAR) and optical satellite data. Two case studies have been proposed: Izmit (1999; Turkey) and Bam (2003; Iran). Both areas have been affected by strong earthquakes causing heavy and extended damage in the urban settlements close to the epicentre. Different procedures for damage assessment have been successfully tested, either to perform a pixel by pixel classification or to assess damage within homogeneous extended areas. We have compared change detection capabilities of different features extracted from optical and radar data, and analysed the potential of combining measurements at different frequency ranges. Regarding the Izmit case, SAR features alone have reached 70% of correct classification of damaged areas and 5 m panchromatic optical images have given 82%; the fusion of SAR and optical data raised up to 89% of correct pixel‐to‐pixel classification. The same procedures applied to the Bam test case achieved about 61% of correct classification from SAR alone, 70% from optical data, while data fusion reached 76%. The results of the correlation between satellite remote sensing and ground surveys data have been presented by comparing remotely change detection features averaged within homogeneous blocks of buildings with ground survey data.

On May 20, 2012, at 4:03 local time (2:03 UTC), a large part of the Po Valley between the cities of Ferrara, Modena and Mantova was struck by a damaging earthquake (Ml 5.9). The epicenter was located by the Istituto Nazionale di Geo-fisica e Vulcanologia (INGV) seismic network [ISIDe 2010] at 44.889 ˚N and 11.228 ˚E, approximately 30 km west of Ferrara (Figure 1). The event was preceded by a foreshock that occurred at 01:13 local time, with a magnitude of Ml 4. The mainshock started an intense seismic sequence that lasted for weeks, counting more than 2,000 events, six of which had Ml >5. The strongest earthquakes of this sequence occurred on May 29, 2012, with Ml 5.8 and Ml 5.3, recorded at 9:00 and 12:55 local time, respectively. The epicenters of the May 29, 2012, events were located at the westernmost part of the rupture zone of the May 20, 2012, earthquake (Figure 2). The May 20 and 29, 2012, earthquakes were felt through the whole of northern and central Italy, and as far as Switzerland, Slovenia, Croatia, Austria, south-eastern France and southern Germany. Historical information reveals that the seismic activity in the Po Valley is moderate […]

On 6 April 2009 an Mw = 6.3, Imax = 9–10 earthquake struck the Abruzzi region of Central Italy (http://portale.ingv.it/highlights/view?set_language=en). We find similarities in some peculiar characteristics of the 2009 sequence and some historical events that occurred in the area, in particular in 1461 and 1762. We observed strong analogies in the distribution of the intensities and in the areas of the strongest effects produced by these shocks, as well as in the temporal evolution of the events. The 2009 quake severely devastated the town of L'Aquila (∼ 73,000 inhabitants) and tens of villages located in the middle...