The article focuses on investigation of the effects of usage of acidic electrolyzed water (AEW) with different sodium chloride concentration (0.001%, 0.01%, and 0.1%) for the preparation of carrageenan and gelatine hydrosols and hydrogels. To determine physiochemical properties of hydrosols, the pH, oxidation-reduction potential (ORP), available chloride concentration (ACC) and rheological parameters such us gelation and flow temperatures were measured. The samples were also characterized using Fourier transform infrared spectroscopy (FT IR) and texture profile analysis (TPA). Additionally, the article contains an analysis of antibacterial activity of carrageenan and gelatine hydrosols incorporated with acidic electrolyzed water, against Staphylococcus aureus and Escherichia coli. The FT IR spectra demonstrated that the structure of gelatine and carrageenan are not significantly affected by electrolyzed NaCl solution components. Furthermore, TPA analysis showed that the use of AEW did not cause undesirable changes in hydrogels layer. The microbiological analysis confirmed inhibition of bacterial growth by hydrosols to about 2.10 log reduction. The results showed that the range of reduction of microorganisms depends on the type AEW used. This might be explained by the fact that the lowest pH and the highest ACC values of hydrosols were obtained for samples with the longest period of exposure to electrolysis (10 min) and the highest amount of NaCl (0.1% w/v). These results suggest that hydrogels and hydrosols incorporated with AEW may be used for food preservation.
In the present work, the effects of different operating parameters on the performance of a gravity-assisted heat pipe-based indirect evaporative cooler (GAHP-based IEC) were investigated. The aim of the theoretical study is to evaluate accurately the cooling performance indicators, such as the coefficient of performance (COP), wet bulb effectiveness, and cooling capacity. To predict the effectiveness of the air cooler under a variety of conditions, the comprehensive calculation method was adopted. A mathematical model was developed to simulate numerically the heat and mass transfer processes. The mathematical model was validated adequately using experimental data from the literature. Based on the conducted numerical simulations, the most favorable ranges of operating conditions for the GAHP-based IEC were established. Moreover, the conducted studies could contribute to the further development of novel evaporative cooling systems employing gravity-assisted heat pipes as efficient equipment for transferring heat.
28 July 2015 in International Journal of Food Science and Technology
The treatment with acidic electrolyzed water (AEW) is a promising disinfection method due to its effectiveness in reducing microbial population. The aim of the study was to evaluate physicochemical properties of chitosan/HPMC films incorporated with lysozyme and acidic electrolyzed water. In the composite films, decreasing film solubility and increasing concentration of sodium chloride solution and prolongation of electrolysis time were observed. Electrolysis process with sodium chloride induces spongy network of film structure. The use of AEW has not changed chemical composition of films which was proved by 1H NMR, MALDI-TOF, and FT-IR spectroscopy. The research confirmed that electrolysis significantly improved thermomechanical properties of the examined films. The contact angle values of the films were quite similar and ranged between 56° and 73°. The increase of salt concentration used in the electrolysis process had an impact on increasing flexibility of samples. Application of electrolyzed water in commonly used food processing systems is possible. Fusion of AEW and biopolymers may provide better integration with coated food product and multidirectional protecting effect. The treatment with acidic electrolyzed water (AEW) is a promising disinfection method due to its effectiveness in reducing microbial population. The aim of the study was to evaluate physicochemical properties of chitosan/HPMC films incorporated with lysozyme and acidic electrolyzed water. In the composite films, decreasing film solubility and increasing concentration of sodium chloride solution and prolongation of electrolysis time were observed. Electrolysis process with sodium chloride induces spongy network of film structure. The use of AEW has not changed chemical composition of films which was proved by 1H NMR, MALDI-TOF, and FT-IR spectroscopy. The research confirmed that electrolysis significantly improved thermomechanical properties of the examined films. The contact angle values of the films were quite similar and ranged between 56° and 73°. The increase of salt concentration used in the electrolysis process had an impact on increasing flexibility of samples. Application of electrolyzed water in commonly used food processing systems is possible. Fusion of AEW and biopolymers may provide better integration with coated food product and multidirectional protecting effect.
1 September 2015 in Bulletin of the Veterinary Institute in Pulawy
The influence of acidic electrolysed water (AEW) treatment on inactivation of pure bacterial cultures inoculated onto the surface of agarised media and surface microbiota of pork meat were examined. Low-concentrated AEW (low concentration of sodium chloride and low current electrolysis) was generated by electrolysis (5 or 10 min) of 0.001% or 0.01% NaCl solution. The number of viable microorganisms was determined using a plate count method. The effect of AEW on bacterial cell morphology were investigated using scanning electron microscopy (SEM). After treatment with AEW, a significant, about 3.00 log reduction of Pseudomonas fluorescens, Yersinia enterocolitica, Escherichia coli, Staphylococcus aureus, Bacillus subtilis, Listeria monocytogenes, and Micrococcus luteus populations was observed. In the AEW treatment of pork, the highest reduction of total number of microorganisms (2.1 log reduction), yeast and moulds (2.5-2.6 log reduction), and psychrotrophs (more than 1 log reduction) was observed after spraying with 0.001% NaCl subjected to 10 min electrolysis. SEM revealed disruption and lysis of E. coli and S. aureus cells treated with AEW, suggesting a bactericidal effect. Higher available chlorine concentration (0.37-8.45 mg/L), redox potential (863.1-1049.8 mV), and lower pH (2.73-3.70) had an influence on the shape of bacteria and the number of breaks in the bacterial membrane.