In this experimental study, the statistical response surface methodology (RSM) based Box-Behnken design (BBD) was selected for evaluation of the effect of different parameters (solution pH,H2O2 concentration, current density, and time) and their interactions on the degradation of the diazinon by electro Fenton process. The results showed that the quadratic model is suitable for the obtained data (P-value = 0.0001) and in optimal process performance conditions was set equal to 100%. Regression analysis with a high correlation coefficient (R2 = 0.9980) and the model value of 765.56 indicated the adequacy of the model. Based on the results, the electro-Fenton process is an efficient technique for removing diazinon from aqueous media.
For this data article the adsorption of Basic Blue 41 (BB 41) dye by activated carbon derived from filamentous algae (AAC) of available in agriculture waste as cheap adsorbents were examined. Activated carbon has been widely used as an adsorbent regard to its massive specific surface area, high porosity, reusability and thermal stability for the removal of pollutants from effluent. These filamentous algae grow widely in irrigation streams, causing decreasing speed of water flow and are not even eaten by livestock so are considered agricultural wastes. They can be used as precursors for activated carbon preparation and as adsorbent for the dye removal. The data of initial dye concentration (50-200 mg//L), pH of dye solution (3-9), adsorbent dosage (0.25-2 g/L), and contact time (5-200 min), were assessed. The structure of AAC was characterized by X-ray diffraction and Fourier transforms infrared spectroscopy. Activated carbon with a 94% removal of dye at concentration of 100 mg/L, pH 9, and adsorbent dose 1 g/L after 90 min. The data of isotherms and Kinetics indicated that the experimental data are fitted to Langmuir and second-pseudo-order models. Under the optimum conditions, maximum adsorption capacity of the AAC in Langmuir model enhanced to amount of 125 mg/g. According to the experimental data, filamentous algae are a suitable raw material for activated carbon production.
8 January 2020 in Korean Journal of Chemical Engineering
The coloured wastewater from the textile industries may show toxic or carcinogenic effects on the organism, when discharged into the rivers and lakes, which are changing their biological life. Therefore, in this study, the removal of basic violet 16 was investigated by a magnetite graphene oxide nanocomposites (Fe3O4@GO) optimising by the response surface methodology based on Box–Behnken method. Fe3O4@GO nanocomposite was prepared by a facile in situ co-precipitation method, resulting in a suitable composite for the adsorption of dye. The structure and morphology of the Fe3O4@GO adsorbent were investigated using XRD, FT-IR, SEM, BET and VSM techniques. Base on the SEM images, the Fe3O4 NPs were distributed between the GO sheets and empty spaces with visible large pores between GO sheets. Also, the results of the FT-IR analysis showed that the dominant group was carboxyl group. The various parameters were evaluated in the process such as pH, reaction time, adsorbent dose and initial concentration of dye. The proposed model (quadratic) was approved with a high correlation coefficient (R2 = 0.98) and (R2adj = 0.97). Desirable removal of dye (efficiency: 95.03%.) was obtained under following conditions: the dye concentration of 62.5 mg L−1, the absorbance of 0.2 g L−1, the reaction time of 60 min and solution pH of 7.5. The results of isotherms and kinetics adsorption study showed that the adsorption process follows the Langmuir isotherm (R2: 0.98) and the pseudo-second-order kinetic (R2: 0.99) models. The present study showed that the Fe3O4 @GO adsorbent has a high efficiency in the removal of violet 16.