A short plunging jet technique was developed to produce small bubbles in continuous casting tundish, with argon sealing, in order to promote the removal of inclusions smaller than 50 μm. The liquid steel coming out of the ladle shroud is accelerated and vibrated by gravity, leading to gas entrainment. This novel approach is free from bubbles growing along the nozzle surface due to the poor wetting condition, which is applicable to producing small bubbles in liquid steel. Water modeling was carried out to investigate the impact of the free-fall length on gas entrainment by a short plunging jet. The results show that gas can be entrained into the liquid bath with a free fall longer than 15 mm. Part of the entrained gas is separated from the gas sheath by the rough surface of the inflow stream, forming initial bubbles. These initial bubbles are further refined into small ones of 0.4~2.5 mm due to the turbulent flow in the pouring region. The cylindrical shield can effectively isolate the surface fluctuation caused by the short plunging jet; thereby, a stable slag layer in the tundish can be maintained during gas entrainment.
Hydrogen removal of H-supersaturated liquid steel produced in a hydrogen-rich environment in an industrial vacuum degasser (VD) is simulated here using a two-phase (argon–steel) Eulerian model. The dehydrogenation efficiency is evaluated for a series of ladle plug layouts and argon-purging modes. Increasing the plug number from the prototype double-plug of the ladle to four or slightly prolonging the degassing time of a triple-plug ladle enables to obtain the specified dehydrogenation efficiency and the end-point hydrogen level. Varying the plug position of the triple-plug ladle makes no significant difference in the dehydrogenation efficiency, which, however, is improved by adjusting the plug angle. For the triple-plug ladle, the non-uniform argon-purging mode improves the melt hydrodynamic conditions, but the optimal dehydrogenation performance is achieved in the uniform mode. The plug number has the greatest impact on the dehydrogenation efficiency compared to the other ladle designs considered. The high-efficiency dehydrogenation of H-supersaturated liquid steel in the VD can be achieved through using the quadruple plugs, or by using the triple plugs positioned at 0.57R, 0.57R, and 0.41R and the angles of 108.6° and 71.4°, with the uniform argon-purging flow rate.
13 July 2026 in Metallurgical and Materials Transactions B