Elevated levels of contaminants in surface and ground water pose serious and adverse health challenges in the twenty-first century. It is imperative that the quality of life of people without safe drinking water is improved by providing safe, clean and affordable water using appropriate purification technology. Natural clay and rice husk-Na2CO3 modified clay were used to produce expanded clay aggregates adsorbents. Characterizations were done using SEM, XRD, XPS and BET to reveal their salient features. Filtration studies were carried out to ascertain the disinfection assay of E. Coli and removal efficiencies of nitrate and phosphate. Batch adsorption experiments were employed to determine the effect of pH, contact time and adsorbent dosage for effective removal of Arsenic (III) and lead (II) including isotherm models. Aluminosilicates and associated minerals with high surface areas between 456.143–566.998 m2/g and significant adsorption sites were revealed. Log four bacteria disinfection assay was achieved. Reduction efficiencies for phosphate and nitrate for all adsorbents varied from 27.33% to 76% and 10.67% to 46% respectively. High correlation coefficients made Langmuir isotherm model more favourable than Freundlich model. The adsorption capacities for both lead and arsenic were high and reaction was fast, making the adsorbents suitable for water remediation applications.
Plasticity is an essential property of clay that determines its suitability for water filtration. There are no published works on the plastic behavior of clays from the study locations. The plastic behavior of seven Nigerian clays was examined using plasticity indices and compressive stress parameters in relation to chemical compositions and moisture content. The objective is to determine plastic behavior of some Nigerian clays and their suitability in production of Expanded Clay Aggregates (ECA) for water filters. Compressive stresses and deformation parameters were determined experimentally and compared theoretically. Atterberg limits (D 4318) were used to determine the plasticity indices. Chemical compositions of the samples were examined with XRF and correlated with plasticity and mineral contents of the clays. The clays are aluminosilicates with SiO2/Al2O3 ratio of 1.61 to 3.03 and plastic indices of 8 to 49. Low plastic indices (8–11) and low compressive stresses parameters were observed for kaolinite clays (0.002 MPa) due to their low affinity for water while zeolite rich clays showed high plastic indices (46 and 49) for Obowo and Minna and sharp difference in their compressive stresses parameters (0.15 and 0.03 MPa) at optimum moisture contents of 57% and 53%, respectively. Despite varying moisture content, chemical and mineral compositions, all curves showed similar trends apart from kaolinites at 40% moisture content. Relationships exist among microstructural properties, chemical composition, moisture content, compressive strength, and plasticity indices of the clays. The plastic behaviors show they are suitable for development of ECA for water filters.