The depletion of conventional oil reserves creates a significant demand for the development and improvement of methods and technologies for the production of hard-to-recover oil. A huge potential for hard-to-recover oil in Western Siberia lies in the Pokur suite (PK). These deposits are characterized by high oil viscosity and, accordingly, early water breakthrough. This study identifies and substantiates an effective technology for oil production from such and similar deposits using polymer flooding. The obtained data are based on research of the geological structure, the main reservoir properties and those of its fluids, chemical and laboratory methods of analysis, and the results of mathematical and hydrodynamic modeling. According to the results of hydrodynamic modeling, the greatest technological effect of polymeric water flooding is observed in the model of collector permeability at 70 mD and above 1000 mD, but this technology is not recommended for reservoirs with an average permeability of less than 10 mD. Implementation of the best practices through the prism of the resource nexus allows sustainable water management by applying environment-friendly polymers for enhanced oil recovery and contributes to the UN Goal 6 of clean water and sanitation.
Recently, more and more new oil fields entering commercial production are complicated by the content of high-viscosity products, which are located at relatively shallow depths. For the rational development of such fields, a network of horizontal wells is used. A special feature of these objects is a weakly cemented reservoir, which leads to significant sand occurrence during well operation. At the same time, the removal of mechanical impurities cannot be avoided even when using complex measures, including the use of various filters. There are quite a few methods describing the behavior of mechanical impurities in gas–liquid flows. The purpose of the work was to analyze the removal of mechanical impurity particles from horizontal wells with high-viscosity oil. A model of a typical well in the OLGA software was created, and data on the types of particle removal were obtained. As a result of calculations, the quality of removal for different diameters of mechanical impurities was determined, and the dependence of the critical diameter on the well flow rate was constructed.