In this study, oxygen reduction behavior of TiH2 powders during dehydrogenation process was investigated based on thermodynamics. During the hydrogenation–dehydrogenation (HDH) method to fabricate Ti powder, TiH2 was formed from a Ti sponge through hydrogenation annealing, and was easily pulverized even by ball milling due to its brittle nature. The ball milling process caused an increase in the oxygen concentration from 0.133 to 0.282 wt %, and transmission electron microscopy and X-ray photoelectron Spectroscopy results demonstrated that the formation of oxide layers such as TiO and TiO2 formed on the surface of the TiH2 powder resulted in the higher oxygen content. Dehydrogenation, which is the process originally conducted to eliminate hydrogen from TiH2, was used to remove and/or reduce oxygen, resulting in the reduction of the oxygen concentration from 0.282 to 0.216 wt %. Thermodynamic calculations confirmed the possibility of oxygen reduction by atomic hydrogen but molecular hydrogen has no function for the oxygen reduction. Glow discharge mass spectrometry (GD-MS) analysis, which checks H2O flow as an evidence of the oxygen reduction by hydrogen, supported the fact that the atomic hydrogen formed during the dehydrogenation process is able to play a critical role in decreasing the oxygen content.
6 June 2016 in International Journal on Interactive Design and Manufacturing (IJIDeM)
Laser cladding is an additive manufacturing process in which a laser generates a melt pool on the substrate material while a second material in a powder or wire form is injected into that melt pool. Among all laser manufacturing processes, laser cladding offers the most extensive variety of possibilities to alter a component at its surface. Despite immense potential and advancements, the process model of microstructure evolution and its coupling with macro parameters of the laser cladding process has not been fully developed. To address this issue, a process model of microstructure evolution has been studied by utilizing a phase-field method. The phase-field method has become a widely used computational tool for the modeling of microstructure evolution with the advantage of avoiding tracking the interface explicitly and satisfying interfacial boundary conditions. In present work, the numerical solutions of a phase-field model have been analyzed. The linking of macroscale process and microstructure evolution was examined by considering the relationship of macro- and microparameters. The effects of thermal noise and melt undercooling on the solidification microstructure have also been studied. The predicted results with different undercoolings were compared with the microsolvability theory and a good agreement was found. Different solidification morphologies of different locations in the melt pool are also investigated. It was found that it is not the mass transfer but the heat transfer in the melt pool that dominates the solidification process.
24 December 2019 in Metals and Materials International
Electron paramagnetic resonance (EPR) for specially doped LiNbO3 crystals was determined. Study of the charge transfer and the photosensitivity in these crystals determined the ions, which participate on the charge transfer processes. In doubly doped crystals with Fe:Cr and Fe:Ce the decay of the EPR signal was less than the decay time in LiNbO3:Fe:Mn. some inherited impurities in these crystals like Mn and Fe were detected. The effect of the inherited impurities on the decay and growth of the EPR signal was estimated by comparing the results with homegrown LiNbO3 crystals.
10 January 2023 in Metals and Materials International