In the present work, the design and the environmental conditions of a micromachined thermal accelerometer, based on convection effect, are discussed and studied in order to understand the behavior of the frequency response evolution of the sensor. It has been theoretically and experimentally studied with different detector widths, pressure and gas nature. Although this type of sensor has already been intensively examined, little information concerning the frequency response modeling is currently available and very few experimental results about the frequency response are reported in the literature. In some particular conditions, our measurements show a cut-off frequency at −3 dB greater than 200 Hz. By using simple cylindrical and planar models of the thermal accelerometer and an equivalent electrical circuit, a good agreement with the experimental results has been demonstrated.
11 June 2018 in IEEE Transactions on Nuclear Science
In this paper, we present the first steps in the development of a new generation of ultrasonic sensors devoted to fission gas characterization in a material testing reactor harsh environment. The piezoelectric active material is a sodium bismuth titanate thick film fabricated using a screen-printing method. Characterization of piezoelectric and dielectric properties and material parameter studies based on temperature were carried out. The key results of this paper are demonstrated and discussed in terms of feasibility for application to a new sensor device operating at high temperature (350 °C). An acoustic test in a cylindrical cavity shows high sensitivity to measurements of liquid substances at room temperature. To verify its applicability to gas detection, a theoretical model based on electromechanical properties and impedance matching equations was introduced. This model was used in the studies on gas measurement under room temperature and at 350 °C. It was theoretically shown that the sensor was able to operate for gas in situ under harsh temperature conditions.
As well as many modern devices, thermal accelerometers (TAs) need a sophisticated mathematical simulation to find the ways for their performance optimization. In the paper, a novel approach for solving computational fluid dynamics (CFD) problems in the TA’s cavity is proposed (MQ-RFM), which is based on the combined use of Rvachev’s R-functions method (RFM) and the Galerkin technique with multiquadric (MQ) radial basis functions (RBFs). The semi-analytical RFM takes an intermediate position between traditional analytical approaches and numerical methods, such as the finite-element method (FEM), belonging to the family of the so-called meshless techniques which became popular in the last decades in solving various CFD problems in complex-shaped cavities. Mathematical simulation of TA by using the MQ-RFM was carried out with the purpose to simulate the temperature response of the device and to study and improve its performance. The results of numerical experiments were compared with well-known analytical and numerical benchmark solutions for the circular annulus geometry and it demonstrated the effectiveness of the MQ-RFM for solving the convective heat-transfer problem in the TA’s cavity. The use of solution structures allows one to take a relatively small number of expansion terms to achieve an appropriate accuracy of the approximate solution satisfying at the same time the given boundary conditions exactly. The application of the MQ-RFM gives the possibility to obtain semi-analytical solutions to the diffusion-convection problems and to identify the main thermal characteristics of the TA, that allows one to improve the device performance.