SiC was modified by fluorine-containing organic substance 1H,1H,2H,2H-trifluoro-noctyltriethoxysilane (FAS) to change its hydrophilicity from hydrophilic to superhydrophobic nanoparticles, and the optimum conditions for hydrophobicity were effectively explored. Then, different content of fluorine-modified SiC (F–SiC) nanoparticles were added to the epoxy resin (EP) matrix to prepare composite coating samples. The results showed that the surface of SiC was modified by FAS to show superhydrophobicity, and the dispersion in EP was significantly improved. After adding F–SiC, the hydrophobicity, wear resistance and corrosion resistance of the coating were significantly improved. In addition, the corrosion resistance of the composite coating containing different contents of F–SiC was analyzed through electrochemical and salt spray tests. The results showed that the corrosion resistance of the coating was the best when the addition amount was 3 wt %. In general, the composite coating with 3 wt % F–SiC had the best overall performance. Compared with the EP coating, the water contact angle of 3 wt % F–SiC/EP composite coating was increased by 62.9%, the friction coefficient was reduced by 73.5%, and the corrosion current was reduced by three orders of magnitude. This study provides a new idea for the development of ultra-wear-resistant and anti-fouling heavy-duty coatings.
When mesoporous nanomaterials and graphene oxide have been used in anti-corrosion coatings, new nanocoatings have attracted greater attention. Adding nano-fillers with special structures and corrosion inhibitors to epoxy coatings has been proven to effectively enhance the corrosion resistance of coatings. However, studies have pointed out that the added corrosion inhibitors are easily degraded by UV light and react with the metal substrate or materials in the coating, resulting in a significant reduction in the service life of the coating. To this end, in this study, the corrosion inhibitor was encapsulated in mesoporous silica with pH response, and the functional silica was composited with graphene oxide to prepare novel graphene oxide/functional mesoporous silica nanoparticles. Coatings with this special filler added have strong anti-corrosion potential and can be applied in marine anti-corrosion contexts, such as containers, in the future. The filler not only has a physical barrier ability but also can effectively prevent the degradation of the inhibitor due to ultraviolet rays. At the same time, in the early stage of corrosion, the release of inhibitors can be effectively controlled by the change in PH to achieve the purpose of preventing corrosion. UV spectrophotometry confirmed the stable encapsulation and controlled release of the inhibitor. Electrochemical-impedance spectroscopy showed that the |Z|0.01 Hz value of the smart anti-corrosion epoxy coating was about 10,000 times higher than that of the pure epoxy coating. Through the FT-IR mapping test, it was found that in the area of mechanical damage, the alkaline environment created by the initial corrosion can induce the release of tannic acid and react with common corrosion products to form iron tannins, which effectively inhibits the further occurrence of corrosion. This method provides an effective method for the design of heavy-duty anti-corrosion coatings.