In this paper studies on sound absorption of the thermoplastic composites on the basis of waste natural fibers are presented. Cotton fibers and cellulose ultra-short and ultra-fine fibers obtained from flax fibers following enzymatic and additional mechanical treatment were used as the components of polylactide composites, and their influence on sound absorption behavior was investigated. The composites were obtained from a pressing process of fibrous multilayer structures. The sound absorption properties of three types of composites were compared: composites reinforced by cotton fibers, composites reinforced by cellulose ultra-short and ultra-fine fibers, and composites reinforced by cotton fibers and cellulose ultra-short and ultra-fine fibers. The role of cellulose ultra-short and ultra-fine fibers in changing the sound absorption properties of composites was determined. It has previously been shown that using natural fibers with a thermoplastic polymer results in increased sound absorption. The best improvement of sound absorption can be obtained by combining cotton fibers and cellulose ultra-short and ultra-fine fibers, especially nanofibers, as a reinforcement.

This article presents thermoplastic sound-absorbing composites manufactured on the basis of renewable raw materials. Both the reinforcing material and the matrix material were biodegradable and used in the form of fibers. In order to mix flax fibers with polylactide fibers, the fleece was fabricated with a mechanical system and then needle-punched. The sound absorption of composites obtained from a multilayer structure of nonwovens pressed at different conditions was investigated. The sound absorption coefficient in the frequency ranging from 500 Hz to 6400 Hz was determined using a Kundt tube. The tests were performed for flat composites with various structures, profiled composites, and composite/pre-pressed nonwoven systems. Profiling the composite plate by convexity/concavity has a positive effect on its sound absorption. It is also important to arrange the plate with the appropriate structure for the incident sound wave. For the composite layer with an added pre-pressed nonwoven layer, a greater increase in sound absorption occurs for the system when a rigid composite layer is located on the side of the incident sound wave. The addition of successive nonwoven layers not only increases the absorption but also extends the maximum absorption range from the highest frequencies towards the lower frequencies.

The quest for sound-absorbing materials that are not only environmentally friendly, but also sustainable is the foremost reason for natural fibre-acoustic materials. Bark cloth is a natural non-woven fabric that is largely produced from Ficus trees. An exploratory investigation of bark cloth a non-woven material and its reinforcement in epoxy polymer composites has been fabricated and investigated for the sound absorption properties so as to find the most suitable applications and also to see whether bark cloth can be used in some applications in place of man-made fibres. Three types of material species were investigated with their respective composites. The fibre morphology showed bark cloth to be a porous fabric that showed promising sound absorption properties at higher frequencies. The sound absorption results of four-layer material selections of Ficus natalensis, Ficus brachypoda and Antiaris toxicaria bark cloth showed sound absorption coefficient of 0.7; 0.71 and 0.91 at f > 6400 Hz, respectively. The bark cloth reinforced laminar epoxy composites had reduced sound absorption coefficients, which ranged from 0.1 to 0.35, which was attributed to decreased porosity and vibration in the bark cloth fibre network.