Virtually every concrete structure comes into contact with abrasive effects of flowing media or solids, which have a direct impact on the durability of concrete. An abrasive effect is most pronounced in transport or water management structures, and these structures are often designed for a significantly longer service life (usually 100 years). This research evaluates the influence of the filler component in terms of the type of aggregate and its mineralogical composition on concrete abrasion resistance. As part of the impact of the binder component, several concrete mixtures were produced using the same aggregate and maintaining the same strength class with the addition of different types of active and inert mineral additives. In other parts of the research, the effect of adding fiber reinforcement on the abrasion resistance of concrete was verified. Mutual connections and correlations in different age groups (7, 28 and 90 days) were sought for all obtained results. The abrasion resistance of the composite was monitored by using standard procedures, especially using a Böhm device. It was found that for good abrasion resistance of concrete, it is not necessary to produce concretes with high strength classes using often expensive mineral additives (microsilica) and quality aggregates, but the maturation time of the composite and its microstructure plays an important role.
1 April 2019 in International Journal of Engineering and Technology
The presented research aims to clarify the specific effect of the individual components of concrete with Portland cement CEM I 42.5 R on the volume changes of concrete. The effect of the filler component was evaluated from the point of view of the composition and type of aggregate (crushed versus mined) and from the point of view of the mineralogical composition of the aggregate. Concrete formulas with a maximum aggregate grain size of 16 and 22 mm were assessed. The effect of the binder component on the shrinkage of the concrete was monitored on the concrete mixtures produced using the same aggregate and maintaining the same strength class of concrete, C 45/55. The effect of the addition of finely ground limestone, finely ground granulated blast furnace slag and coal high-temperature fly ash was monitored. It was found that the maximum aggregate grain and the type of grading curve do not have a significant effect on the volume changes of concrete. Concretes with mined aggregates showed lower shrinkage than concretes with crushed aggregates. The most significant is the effect of the type of aggregate on the volume changes in the first 24 h. Mineral additives have a positive effect on the elimination of the volume changes of concrete, while the addition of high-temperature fly ash proved to be the most suitable.
The use of Ground Granulated Blast-furnace Slag (GGBS) in concrete mixes has become commonplace in modern concrete technology, for reasons including its positive influence on selected parameters of the concrete mix in its fresh and hardened state. However, increasing pressure on the production of blended cements, along with economic difficulties due to grinding or the closure of blast furnaces and the associated longer transport distances, are resulting in lower availability and increased prices for this raw material. It is accordingly necessary to look for other possible solutions or alternatives to optimise the composition of the concrete mix, as this would make it possible to reduce not only the amount of binder but also the proportion of GGBS in the mix while maintaining the technical parameters. One possible solution could be to combine GGBS with an inert admixture in an optimal ratio to ensure maximum compactness of the cement matrix.
1 April 2019 in International Journal of Engineering and Technology