This paper presents the results of physicochemical and tribological tests of vegetable oils obtained by the supercritical fluid extraction method from berry seeds. The research was conducted by using these oils as the raw material for the biodegradable hydraulic working fluids. The oils were assessed in terms of kinematic viscosity, anti-wear properties, resistance to oxidation and corrosive effects to copper and the pour point. The best results were achieved in the case of the blackcurrant seed oil. In order to confirm the practical possibility of using vegetable oils as working fluids for hydraulic couplings, experimental tests of the hydrodynamic clutch filled with blackcurrant seed oil were carried out. Based on the obtained research results, it was found that oils from berry plant seeds produced by supercritical extraction could be used in the future as potential working fluids for hydraulic systems.
The paper presents the application of a strain gauge sensor and a viscous brake filled with an electrorheological (ER) fluid, which is a smart material with controlled rheological properties, by an electric field to the fluid domain. For experimental tests, a cylindrical viscous brake was designed. The tests were carried out on a test stand especially prepared for this purpose and suitable for the examination of the impact of the rotational speed of the input shaft and the value of the electric voltage supplied to the viscous brake on pressing forces, taking into account the ER fluid temperature and brake fluid filling level. On the basis of the experimental research results, a viscous brake control system to exert constant pressing forces with feedback from a strain gauge sensor, based on the programmable logic controller, was designed and implemented. This system, using its own control algorithm, ensured a control pressing force within the assumed range, both during the constant and follow-up control. The measurement results obtained during the tests of the viscous brake designed to exert a force were presented in the form of time courses, showing the changes of the pressing force, the electric voltage applied to the brake and the rotational speed of the brake input shaft. The developed ER fluid brake control system with feedback was tested for constant and follow-up control, taking into account the impact of the working fluid temperature. During the test it was possible to obtain a maximum pressing force equal to 50 N for an electric voltage limited to 2.5 kV. The resultant error was lower than 1 N, wherein the adjustment time after changing the desired value of the force was around 1.5 s. The correct operation of both the brake and the control system, as well as the compatibility of the pressing force value and time adjustment, were determined. The main technical contribution described in this article is the design of a new type of DECPF and a new method for its control with the use of a specifically programmed programmable logic controller which simulates the proportional-integral controllers’ operation.
The article describes design optimization of a viscous disc clutch with an electrorheological (ER) fluid. The design optimization is conducted based on mathematical models of ER fluid and clutch geometry. As important issues for the optimal design, the assumed values are: the torque transferred by the clutch, the dimensions of the clutch and the steady-state operating temperature of the clutch. The assumed design variables are: the angular velocity of the input shaft, the number of working gaps of the clutch and the selected dimensions of the clutch. The aim of the design optimization is to search for design variables such as the angular velocity of the input shaft, the number of working gaps of the clutch and the selected dimensions of the clutch, for which the clutch transfers the highest possible torque, while the dimensions of the clutch are small and the steady-state operating temperature is low. The design optimization is conducted searching at least two different objective functions created taking into account the volume, the transferred torque and the steady-state operating temperature of the clutch. Two numerical methods are used: the Monte Carlo method and the Genetic Algorithm method. The optimization calculations are performed for two sets of design variables, consisting of three and eight elements, and a final prototype designed via the optimization is depicted with the principal design parameters.