Microphone arrays of various sizes and shapes are widely employed in consumer electronics devices such as smart speakers, speakerphones, smart TVs, smartphones, PCs, and headphones. Therefore, the possibility of creating arrays of arrays (i.e., meta-arrays), by easily connecting several smaller units, is particularly interesting: it allows for different shapes, with an increased number of microphones and improved performance, while keeping costs low. In this paper, full-digital microphone meta-arrays are presented: they are constituted by an arrangement of several triangular units, each featuring four digital Micro Electro-Mechanical Systems (MEMS) capsules connected in daisy-chain through the Automotive Audio Bus (A2B). Two prototypes have been built: a planar meta-array made of seven triangles (28 capsules) and a 3-dimensional meta-array with 14 triangles (56 capsules). Numerical simulations were carried out and compared against experimental measurements performed on the prototypes, showing an excellent matching. Finally, the 3-dimensional meta-array was compared with a spherical microphone array widely considered the state-of-the-art equipment in the last decade, demonstrating its potential in telecommunication applications.
24 October 2023 in IEEE Transactions on Industry Applications
Condition Monitoring (CM) aims at damage identification through the measurement of various data collected from the systems under investigation (civil structures, mechanical parts, or industrial machineries) such as acceleration, temperature, displacement, and dynamic properties variation. Synchronization between the measured signals is mandatory for the processing of diagnostic metrics and modal analysis, which is why most of the monitoring systems today consist of a centralized acquisition unit to which analog transducers are connected. However, this solution entails a high cost of equipment and the use of long analog cables for each transducer. A full-digital network solution has been developed to solve these problems. The acquisition network is composed of Interface Boards for interfacing with the data storage system (e.g., a personal computer) and Acquisition Nodes integrating Micro Electro-Mechanical Systems (MEMS) digital triaxial accelerometers. The Interface Boards can be connected via Universal Serial Bus (USB) or Local Area Network (LAN), while the Acquisition Nodes are connected in daisy-chain via a digital bus implemented on an Unshielded Twisted Pair (UTP) cable. The proposed solution simplifies wiring, reduces system cost, and provides accurately synchronized signals. Experimental measurements on a truss model and a motor test bench for ball bearing failures diagnostic are presented, to demonstrate the effectiveness of the solution in civil and industrial applications, compared to a traditional analog laboratory-grade system.
In a multiple parallel-connected inverters system, limiting the circulating current phenomenon is mandatory since it may influence efficiency and reliability. In this paper, a new control method aimed at this purpose and conceived to be implemented on a Field Programmable Gate Array (FPGA) device is presented. Each of the inverters, connected in parallel, is conceived to be equipped with an FPGA that controls the Pulse-Width Modulation (PWM) waveform without intercommunication with the others. The hardware implemented is the same for every inverter; therefore, the addition of a new module does not require redesign, enhancing system modularity. The system has been simulated in a Simulink environment. To study its behavior and to improve the control method, simulations with two parallel-connected inverters have been firstly conducted, then additional simulations have been performed with increasing complexity to demonstrate the quality of the algorithm. The results prove the ability of the method proposed to limit the circulating currents to negligible values.