29 November 2019 in Physica Status Solidi (RRL) – Rapid Research Letters
For HfO2‐based films, which are mainly prepared by atomic layer deposition, the desired ferroelectric (FE) properties typically vanish while extending the thickness beyond a limit of about 50 nm. Herein, the successful fabrication of a 1 μm‐thick piezoelectric La:HfO2 film is demonstrated using chemical solution deposition, paving the way toward sensor and actuator applications. After identifying the optimal La content, the film thickness is increased from 45 nm to 1 μm. Polarization and strain measurements evidence the persistence of the FE properties at all thicknesses and even a slight improvement due to a better orientation of the polar axis at higher thicknesses. Scanning electron microscopy and X‐ray reflectivity reveal a fine‐grained microstructure and a density of only 80% of the theoretical value, which seems to be a common issue of solution‐deposited HfO2‐based films, based on the performed literature survey. Using tilt‐angle‐dependent X‐ray diffraction scans, homogeneous nucleation is found to be the likely root cause of the observed microstructure. It is suggested that this microstructure issue is key for the optimization of cycling stability of solution‐based films to exploit the full potential of the HfO2 for cost‐efficient, thick piezoelectric films.
1 October 2021 in Journal of the European Ceramic Society
1 June 2020 in Cell Reports Physical Science
25 January 2021 in Applied Physics Letters
Antiferroelectrics have been recently sparking interest due to their potential use in energy storage and electrocaloric cooling. Their main distinctive feature is antiferroelectric switching, i.e., the possibility to induce a phase transition to a polar phase by an electric field. Here, we investigate the switching behavior of the model antiferroelectric perovskite PbZrO3 using thin films processed by chemical solution deposition in different geometries and orientations. Both out-of-plane and in-plane switching configurations are investigated. The critical field is observed to be highly dependent on the direction of the electric field with respect to the film texture. We show that this behavior is qualitatively consistent with a phase transition to a rhombohedral polar phase. We finally estimate the importance of crystallite orientation and film texturation in the variations observed in the literature.
8 December 2020 in Journal of Materials Chemistry C
Chemical solution deposition (CSD) is a well-established process for the fabrication of metal oxide functional layers such as piezoelectric lead zirconate titanate (PZT) thin films. The latter exhibit an enhanced electromechanical response in the presence of {100} crystalline orientation with respect to the substrate surface. Lead titanate (PbTiO3) seed layers are commonly used to promote the growth of this orientation on platinized silicon, which otherwise usually affords the {111} orientation. In this work, we present a comparative study of two solvents used for the preparation of PZT and PbTiO3 solutions for CSD, i.e. the popular but highly carcinogenic and teratogenic solvent 2-methoxyethanol and the benign solvent 1-methoxy-2-propanol. In addition to tremendous health and safety benefits, we show that 1-methoxy-2-propanol-derived PbTiO3 seed layers promote the {100} orientation more efficiently than their 2-methoxyethanol-derived counterparts, owing to their nanocrystalline microstructure and strong orientation. This resulted in a noticeable enhancement of the electrical and piezoelectric properties, with Pr = 38 μC cm−2, Ec = 55 kV cm−1, εr = 1300, tan δ = 0.04 and e31,f ≈ 14 C m−2.
1 April 2019 in Journal of Alloys and Compounds