Two-dimensional (2D) transition metal dichalcogenide (TMD) materials have exceptional optoelectronic and structural properties, which allow them to be utilized in several significant applications in energy, catalyst, and high-performance optoelectronic devices. Among other properties, the nonlinear optical properties are gaining much attention in the research field. In this work, a unique pentagonal TMD material, palladium disulfide (PdS2), is employed as a saturable absorber (SA) in an ytterbium-doped fiber (YDF) laser cavity and mode-locked laser pulse is generated. At first, liquid phase exfoliation is performed to prepare PdS2 nanoflakes. Afterward, the PdS2-nanoflakes solution was incorporated in the side-polished fiber (SPF) to form SPF-based PdS2-SA. By utilizing this SA, a highly stable mode-locked laser pulse is realized at pump power of 160 mW, which has a center wavelength of 1033 nm and a 3-dB spectral bandwidth of 3.7 nm. Moreover, the pulse duration, maximum power output and corresponding single-pulse energy were determined as 375 ps, 15.7 mW and 0.64 nJ, respectively. During the experiment, the mode-locked pulse remained stable till the pump power reached a value of 400 mW and, for the regulation of power, the slope efficiency is calculated at about 4.99%. These results indicate that PdS2 material is a promising nonlinear optical material for ultrafast optical applications in the near-infrared (NIR) region.
We report on the application of a 1 μm solid-state passively Q-switched (PQS) laser and 1, 1.5 μm mode-locked (ML) fiber lasers based on ternary chalcogenide Ta2NiS5 saturable absorber (SA), which were successfully fabricated by liquid-phase exfoliation method (LPE). The nonlinear absorption of the Ta2NiS5-SA was characterized by 0.32 GW/cm2 and 0.25 GW/cm2 saturation intensities with 7.3% and 5.1% modulations depths at 1 μm and 1.5 μm, respectively. A PQS solid-state laser operating at 1.0 μm has been realized with the Ta2NiS5-SA. The maximum average output power, shortest pulse width, pulse energy, and pulse peak power from the PQS laser are 0.257 W, 180 ns, 1.265 μJ, and 7 W. Moreover, highly stable femtosecond laser centered at 1.5 μm, and picosecond centered at 1 μm, ML fiber lasers were obtained using the Ta2NiS5-SA. A 70 dB signal-to-noise ML laser with a pulse duration of 781 fs was observed in the telecommunication window, which is better than the duration of the previously reported lasers based on Ta2NiS5. The corresponding maximum single pulse energy and peak power are 0.977 nJ and 1251 W, respectively. The Ta2NiS5-SA fabricated by the LPE method was applied in near-infrared (NIR) ML fiber lasers (evanescent field interactions) and PQS bulk lasers. The results indicate that Ta2NiS5-SA prepared by the LPE method can be applied in a 1 μm bulk PQS laser and improved by the new combination mode (evanescent field interactions) for better output performance of the fiber laser.
In this work, we successfully fabricated a transmissive saturable absorber (SA) with Ti2CTx MXene using the spin-coating method. By inserting the Ti2CTx saturable absorber into the diode-pumped solid-state (DPSS) Nd:YAG laser, a stable passively Q-switched operation was obtained near 1.06 μm. At a pump power of 4.5 W, we obtained the shortest pulse duration of 163 ns with a repetition rate of 260 kHz. The corresponding single pulse energy and peak pulse power were 3.638 μJ and 22.3 W, respectively. The slope efficiency and the optical conversion efficiency of the laser were 21% and 25.5%, respectively. To the best of our knowledge, this is the first time that Ti2CTx was used in the passively Q-switched solid-state lasers. This work demonstrates that Ti2CTx can be a promising saturable absorber for solid-state laser pulse generation.
In recent years, the transition metal carbonitrides(MXenes) have been widely applied to photoelectric field, and better performance of these applications was achieved via MXene complex structures. In our work, we proposed a MXene core-shell nanosheet composed of a Ti2C (MXene) phase and gold nanoparticles, and applied it to mode-locked and single-frequency fiber laser applications. The optoelectronic results suggested that the performances of these two applications were both improved when MXene core-shell nanosheets were applied. As a result, we obtained a mode-locking operation with 670 fs pulses, and the threshold pump power reached to as low as 20 mW. Besides, a single-frequency laser with the narrowest linewidth of ~1 kHz is also demonstrated experimentally. Our research work proved that MXene core-shell nanosheets could be used as saturable absorbers (SAs) to promote versatile photonic applications.