A pulsed millimeter wave radar operating at a frame rate of 144 Hz is utilized to record 2160 scattering signatures of twelve generic hand gestures. Gesture recognition is achieved by machine learning, utilizing transfer learning on a pre-trained convolutional neural network. This yields excellent classification results with a validation accuracy of 99.5%, based on a 60% training vs. 40% validation split. The corresponding confusion matrix is also presented, showing a high level of classification orthogonality between the tested gestures. This is the first demonstration where data from a pulsed millimeter wave radar is used for gesture recognition by machine learning. It proves that the range-time envelope representation of high frame-rate data from a pulsed radar is suitable for hand gesture recognition. Further improvements are expected for more complex detection schemes and tailored neural networks.
14 July 2015 in IEEE Transactions on Microwave Theory and Techniques
Time-domain material characterization using a leaky lens antenna and an in-house fabricated millimeter-wave wavelet generator using III-V technology is investigated. The wavelet generator produces short high-frequency pulses and is connected to a wideband and nondispersive leaky lens antenna. A purely time-domain methodology is used to extract the complex permittivity of nondispersive and nonmagnetic materials. The permittivity is found from the phase delay and the amplitude mismatch introduced by the object at the carrier frequency of the pulse. The wide bandwidth of the wavelet is used to investigate frequency-dependent material properties. Measurement results from two dielectric slabs are illustrated. The time-domain methodology is verified by frequency-domain measurements and analysis.
In this paper we present a 55 nm gate length In 0.53 Ga 0.47 As MOSFET with extrinsic transconductance of 1.9 mS/μm and on-resistance of 199 Ωμm. The self-aligned MOSFET is formed using metalorganic chemical vapor deposition regrowth of highly doped source and drain access regions. The fabricated 140 nm gate length devices shows a low subthreshold swing of 79 mV/decade, which is attributed to the described low temperature gate-last process scheme.
28 December 2012 in IEEE Transactions on Antennas and Propagation
A readily mass-producible, flip-chip assembled, and slot-coupled III-V compound semiconductor dielectric resonator antenna operating in the millimeter-wave spectrum has been fabricated and characterized. The antenna has a 6.1% relative bandwidth, deduced from its 10 dB return loss over 58.8–62.5 GHz, located around the resonance at 60.5 GHz. Gating in the delay-domain alleviated the analysis of the complex response from the measured structure. The radiation efficiency is better than ${-}0.1$ dB in simulations fed from the on-chip coupling-structure, but reduced by 3.7 dB insertion loss through the measurement assembly feed. Antenna gain measurements show distortion in relation to the simulated pattern, which has a maximum gain of 6 dBi, mainly caused by interference from the electrically large connector used in the assembly. Mode degeneration in the utilized quadratic-footprint resonator was not seen to influence the performance of the antenna. The antenna is intended for on-chip integration and the fabrication technology allows scaling of the operation frequency over the complete millimeter-wave spectrum.
We report on the fabrication of a self-aligned regrown In0.53 Ga0.47As metal-oxide-semiconductor field-effect transistor (MOSFET) and a resonant tunneling diode (RTD). The performance of these devices is demonstrated by integrating them in parallel with an inductive coplanar waveguide stub to form a highly energy-efficient 70-GHz wavelet generator. The fast switching and low on-resistance of the MOSFET make it possible to kick-start and rapidly quench this RTD-driven oscillator circuit, which produces 41-ps-short wavelets at 15 Gpulses/s, a peak output power of 7 dBm, and an energy consumption of 1.9 pJ/pulse.
Bit-error rate measurements for ON-OFF keying modulation at multigigabit per second rates over a V-band wireless link are presented. Serial data-rates from 2.5 to 20 Gb/s were studied for a 2 31 -1 bit random sequence. Error-free data transfer over a 0.3-m link was achieved at up to 10 Gb/s. Acceptable bit-error rates, <; 10 -5 and 10 -3 , were measured at up to 1.5 m for 10- and 15-Gb/s data-rate, respectively. The performance was achieved using a transmitter that consists of an integrated wavelet generator, whereas the receiver was built from off-the-shelf waveguide components. The results demonstrate that very high data-rates may be achieved using binary modulation and short symbols generated in an efficient V-band transmitter. The system is benchmarked against state-of-the-art transceiver systems with multigigabit per second data-rates.