6 January 2020 in IEEE Transactions on Vehicular Technology
28 December 2012 in IEEE Transactions on Antennas and Propagation
A readily mass-producible, flip-chip assembled, and slot-coupled III-V compound semiconductor dielectric resonator antenna operating in the millimeter-wave spectrum has been fabricated and characterized. The antenna has a 6.1% relative bandwidth, deduced from its 10 dB return loss over 58.8–62.5 GHz, located around the resonance at 60.5 GHz. Gating in the delay-domain alleviated the analysis of the complex response from the measured structure. The radiation efficiency is better than ${-}0.1$ dB in simulations fed from the on-chip coupling-structure, but reduced by 3.7 dB insertion loss through the measurement assembly feed. Antenna gain measurements show distortion in relation to the simulated pattern, which has a maximum gain of 6 dBi, mainly caused by interference from the electrically large connector used in the assembly. Mode degeneration in the utilized quadratic-footprint resonator was not seen to influence the performance of the antenna. The antenna is intended for on-chip integration and the fabrication technology allows scaling of the operation frequency over the complete millimeter-wave spectrum.
9 May 2023 in Journal of Applied Physics
To avoid being detected by radar, it is necessary to reduce stealthy military platforms' radar cross section (RCS). The operation of overlaying the metasurface (MS) on the targets is a good solution. A simple chessboard MS structure that can achieve low RCS over a large bandwidth is proposed. Only one unit cell is used to construct the MS. First, the unit cell working in 0.5 and 1−λ modes is designed to achieve a stable phase difference of 180° for y- and x-polarized waves. Then, the unit cells and rotated ones are used to form a chessboard structure with different distributions. The compared results show that the chessboard MS with 2 × 2 quadrants can facilitate the widest 10 dB RCS reduction band of 111% and the largest RCS reduction. The proposed structure exhibits excellent RCS reduction even when irradiated by y- and x-polarized waves at an oblique incidence of 30°.
5 June 2012 in IEEE Antennas and Wireless Propagation Letters
Electromagnetic vector spherical waves have been used recently to model antenna-channel interaction and the available degrees of freedom in multiple-input-multiple-output (MIMO) systems. However, there are no previous accounts of a method to estimate spherical wave coefficients from channel measurements. One approach for this, using a 3-D positioner, is presented and analyzed in this letter. Measurement results are presented and discussed. It is concluded that estimates based on randomly positioned measurements within a volume are less sensitive to noise than those based only on measurements on the surface.