We present a high sensitive Fiber-Optic Microphone (FOM) with a wide measuring range based on a cellulose triacetate diaphragm in this work. The average Signal to Noise Ratio (SNR) of the proposed FOM is measured 50.86 dB in at the frequency range of 100 Hz-20 kHz. In the same spectrum range, the highest SNR for the 2 kHz frequency under 103.16 mPa acoustic pressure is measured at 72.20 dB with 2 Hz resolution bandwidth, which corresponds to a noise-limited minimum detectable acoustic pressure level of 17.91 μPa/ $\sqrt$ Hz. The proposed sensor has advantages of high sensitivity, low cost, and easy fabrication. According to the assessments based on the obtained results, the FOM can be used for medical spectroscopy, imaging applications and for long-distance listening and voice recognition in the military-public security.
This paper describes artificial neural network (ANN) based prediction of theresponse of a fiber optic sensor using evanescent field absorption (EFA). The sensingprobe of the sensor is made up a bundle of five PCS fibers to maximize the interaction ofevanescent field with the absorbing medium. Different backpropagation algorithms areused to train the multilayer perceptron ANN. The Levenberg-Marquardt algorithm, aswell as the other algorithms used in this work successfully predicts the sensor responses.
A fiber optic sensor sensitive to refractive index changes of the outer region of the fiber cladding is presented. The sensor uses bent plastic optical fibers in different bending lengths to increase sensitivity. Measurements were made for low-fat milk, the refractive index of which is altered by some preservatives such as formaldehyde, hydrogen peroxide, and sodium carbonate. Concentrations of the preservatives in the milk were changed between 0% and 14.3% while the refractive indices occurred between 1.34550 and 1.35093 for the minimum (0%) and maximum (14.286%) concentrations of sodium carbonate, respectively. Due to bending-induced sensitivity, the sensor is able to detect refractive index changes less of than 0.4%. The results show that there is excellent linearity between the concentration and normalized response of the sensor.
A low-cost optical sensor based on reflective color sensing is presented. Artificial neural network models are used to improve the color regeneration from the sensor signals. Analog voltages of the sensor are successfully converted to RGB colors. The artificial intelligent models presented in this work enable color regeneration from analog outputs of the color sensor. Besides, inverse modeling supported by an intelligent technique enables the sensor probe for use of a colorimetric sensor that relates color changes to analog voltages.
This study focused on the experimental validation of diaphragm-based Fabry-Perot fiber optic pressure sensors (D-FP-FOPS) with ethylene propylene diene terpolymers (EPDM) diaphragm as designed and analyzed sensor tip theoretically. We also used self-adhesive EPDM rubber as a diaphragm for the first time in the literature. Analytical calculation and finite element method (FEM) analysis were carried out to obtain values of fundamental resonance frequency (f0) and deflection (d) with diaphragm specific values of Young’s modulus and Poisson’s ratio measured by tensile tests. We produced D-FP-FOPS tip with EPDM diaphragm and obtained experimental f0 between 250-400 Hz from extended signal to noise ratio (SNR) plot which figured out with the help of theoretical values of f0. We also analyzed minimum detectable pressure (MDP) mapping which is used to confirm SNR mapping for D-FP-FOPS. We noticed that our sensor could be operated up to 1.6 Pa pressure which confirms the mechanical limit given in the literature. Before production of D-FP-FOPS, a pioneering way which includes design, analytical calculation, FEM analysis, and experimental validation was demonstrated as a novel. Moreover, since we used self-adhesive EPDM tape as a diaphragm material, our sensor tip cost is less than 50whichcapabletocompetewithcommercialsensors.