The free-stream turbulence induced transition occurring under typical low-pressure turbine flow conditions is investigated by comparing linear stability theory with wind tunnel measurements acquired over a flat plate subjected to high turbulence intensity. The analysis was carried out, accounting for three different Reynolds numbers and four different adverse pressure gradients. First, a non-similarity-based boundary layer (BL) solver was used to compute base flows and validated against pressure taps and particle image velocimetry (PIV) measurements. Successively, the optimal disturbances and their spatial transient growth were calculated by coupling classical linear stability theory and a direct-adjoint optimization procedure on all flow conditions considered. Linear stability results were compared with experimental particle image velocimetry measurements on both wall-normal and wall-parallel planes. Finally, the sensitivity of the disturbance spatial transient growth to the spanwise wavenumber of perturbations, the receptivity position, and the location where disturbance energy is maximized were investigated via the built numerical model. Overall, the optimal perturbations computed by linear stability theory show good agreement with the streaky structures surveyed in experiments. Interestingly, the energy growth of disturbances was found to be maximum for all the flow conditions examined, when perturbations entered the boundary layer close to the position where minimum pressure occurs.
To address the increasing interest towards more environmentally friendly naval transportation and the introduction of IMO2020 restrictions on pollutant emissions onboard ships, the present work details the preliminary design of a mini gas turbine engine, i.e., a gas turbine engine with an output power up to 5 MW, for onboard energy generation. In comparison to conventional propulsion systems, gas turbine units benefit from known compactness, which can be further enhanced by employing single-stage uncooled radial machines, according to similar works in the field. As such, the present paper aims to set up a complete procedure that allows a reliable and fast (i.e., requiring a limited computational effort) preliminary design of one-stage centrifugal compressors and radial turbines operating at a high pressure ratio via the use of classical one-dimensional theory. The aerodynamic design outputs in terms of forces and torques are then used to perform a preliminary mechanical design of the shaft by means of a one-dimensional finite element model with commercial software to estimate the corresponding shaft line stress. Despite some necessary geometrical and modeling simplification of the design problem, which results in the unavailability of detailed information on individual components, the employed procedure nevertheless allows a comprehensive overview of the possibilities in terms of maximum machine performance achievable at an early design stage with the associated limited computational requirements. The design procedure and the geometry achieved for the application are presented along with aerodynamic and structural results.