In this paper, the potential of a novel active flow control strategy by means of a modulated pulse jet vortex generator to enhance high-lift performance is demonstrated on a two-dimensional supercritical National Aeronautics and Space Administration (NASA) SC(2)-0714 airfoil with a single slotted trailing-edge flap at a high deflection angle. Fast-switching solenoid valves and compressed air were used as actuators to excite the flow. The vortex generator slot pairs were incorporated into the shoulder of the trailing-edge flap, where the flow separation occurs due to the high flow deflection and severe adverse pressure gradient. In these experiments, in addition to the simple square-wave excitation signal, a burst-modulated excitation signal as a novel pulse jet sequence was implemented to produce the unsteady blowing. The burst-modulation signal was used for the first time for a fast-switching solenoid valve actuator. The experiments were performed at a freestream velocity of with a corresponding Reynolds number of about for a range of angles of attack from 0° to 20° at flap deflection angles from 0° to 35°. The results indicated that the ejection from vortex generator slot pairs was able to prevent flow separation completely in most conditions. These measurements revealed that the burst-modulated excitation was accompanied by more aerodynamic improvements and less air consumption relative to the simple pulsed jet excitation. In the best flow control mode, the results showed about a 12.6% increase in the lift coefficient and a 19.8% decrease in the drag coefficient.
17 February 2016 in International Journal of Computer Applications
In the current research, a series of different combinations of plasma SDBD actuators mounted on a simplified road vehicle have been experimentally studied to find the optimum position of the actuators for controlling the flow separation and reducing the vehicle form drag. Separation point of the flow over the rear ramp, large trailing vortices of the standard model, and laminar separation bubble (LSB) of the rear ramp leading edge are among the most significant factors to be controlled. The experiments were conducted at Reynolds numbers ranging from 0.55 × 106 to 1.11 × 106 in a subsonic wind tunnel while the pressure distribution over the model and its streamwise force balance were accurately measured. Significant drag reduction due to the use of DBD actuators was observed. As such, for the range of tested Reynolds numbers, a maximum of 25.1% of drag reduction in the vehicle drag coefficient could be achieved. The optimum combinations of activation voltages (6, 9, and 12 kV) and wave frequencies (6, 10, and 14 kHz) for plasma actuators were also found. Furthermore, it was observed that SDBD actuators mounted on the rear ramp of the model had a deeper impact on the vehicle drag coefficient compared to the other actuators.
8 August 2015 in Journal of the Brazilian Society of Mechanical Sciences and Engineering
This paper aims to study the effect of different geometrical and electrical parameters, including the voltage, frequency, dielectric thickness, gap width between electrodes, length of electrodes, number of electrodes, and shapes of electrodes, on the induced velocity by the Dielectric Barrier Discharge (DBD) plasma actuators in quiescent air. In addition, the effect of the course of induced velocity evolution in the downstream of actuators has been investigated for different geometries. The streamwise velocity was obtained through the total and static pressure measurement using silicon tubes. The model is a flat plate equipped with a DBD plasma actuator. These experiments were performed for the peak-to-peak voltage range between 8 and 15 kV, and two values of frequency are equivalent to 5 and 10 kHz. The results showed that the multilinear DBD plasma actuator has a maximal induced velocity in the same voltage and frequency as of a single DBD plasma actuator. Evaluation of the induced velocity along the streamwise direction for multilinear, serpentine, and horseshoe actuators showed that these actuators had more than one induced velocity peak.