Triboelectric nanogenerators have garnered significant attention as alternative power sources for wearable electronics owing to their simple structure, easy fabrication, low cost, and superior power output. In this study, a transparent, stretchable, and attachable triboelectric nanogenerator (TENG) is built with an advanced power output using plasticized polyvinyl chloride (PVC)‐gel. The PVC‐gel exhibit very high negative triboelectric properties and electrically insulating PVC became an electrically active material. It is found that a single layer of PVC‐gel can act as a dielectric and as a conducting layer. The PVC‐gel based single layer of triboelectric nanogenerator (S‐TENG) creates output signals of 24.7 V and 0.83 µA, i.e., a 20‐fold enhancement in the output power compared to pristine PVC‐based TENGs. In addition, the S‐TENG can stably generate output voltage and current under stretching condition (80%). The S‐TENG can be implemented as a tactile sensor that can sense position and pressure without combining multiple elements or electrode grid patterns. This study provides new applications of power sources and tactile sensors in wearable electronics.
This study investigates the potential of Ni-doped cobalt ferrite (CoFe₂O₄, N-CF) nanoparticles (NPs)-loaded electrospun poly(vinylidene fluoride) (PVDF) composites for triboelectric nanogenerators (TENGs) to efficiently harness electrical energy from low-frequency mechanical vibrations. PVDF was chosen for its strong electroactive polar phase and inherent tribo-negative properties. Cobalt ferrite (CF) NPs exhibit exceptional charge-trapping capabilities, while nickel’s metallic nature minimizes triboelectric losses due to its conductivity. The synergistic effects of Ni-doped CF (N-CF) fillers enhance charge-trapping efficiency and reduce triboelectric losses, significantly boosting TENG performance. Nickel oxide (NiO), CF, and N-CF NPs were synthesized using a facile co-precipitation method, and PVDF composites were fabricated through electrospinning. The physical and crystalline properties of the composites were characterized using various spectroscopic techniques. Results indicated that incorporating 3 wt% N-CF into PVDF optimized the β-crystalline phase content, crucial for improved output performance. Electrospun PVDF/N-CF (PNC) nanocomposite mats served as the tribo-negative (TN) layer, while aluminum (Al) electrode acted as the tribo-positive (TP) layer in TENG device fabrication. Electrical measurements showed that pristine PVDF/Al TENG devices exhibited lower performance (open-circuit potential—Voc = 22 V, short-circuit current—Isc = 0.61 µA) compared to the optimized Al/PNC3 TENG devices (Voc = 421 V, Isc = 1.0 µA). The importance of a spacer gap was emphasized, with devices incorporating a spacer gap demonstrating superior performance. The optimized TENG device successfully powered over 30 light-emitting diodes and a stopwatch in real-time applications. This study highlights the exceptional output performance of Al/PNC3-based TENGs and provides valuable insights into the development of next-generation sustainable energy harvesting materials.