This paper focuses on the space charge characteristics in TiO2/cross-linked polyethylene (XLPE) nanocomposites; the unmodified and modified by dimethyloctylsilane (MDOS) TiO2 nanoparticles were added to XLPE matrix with different mass concentrations (1 wt%, 3 wt%, and 5 wt%). The scanning electron microscope (SEM) showed that the MDOS coupling agent could improve the compatibility between TiO2 nanoparticles and XLPE matrix to some extent and reduce the agglomeration of TiO2 nanoparticles compared with unmodified TiO2 nanoparticles; the volume resistivity testing indicated that the volume resistivity of TiO2/XLPE nanocomposites was higher than Pure-XLPE and increased with the increase of filling concentrations. According to the pulsed electroacoustic (PEA) measurements, it was concluded that the space charge accumulation was suppressed by filling TiO2 nanoparticles and the distribution of electric field in samples was improved greatly. In addition, it was found that the injection of homocharge was more obvious in MDOS-TiO2/XLPE than that in UN-TiO2/XLPE and the homocharge injection decreased with the increase of filling concentration.
13 July 2018 in IEEE Transactions on Dielectrics and Electrical Insulation
This paper reports on the anti-thermal aging ability enhanced by nanoparticles for polyethylene based nanocomposites. Nanocomposites with concentration of 1 wt% were prepared by using silicon dioxide (SiO 2 ), zinc oxide (ZnO) and magnesium oxide (MgO) nanoparticles. Fourier-transform infrared spectra showed that the low-density polyethylene (LDPE)/MgO nanocomposites had the best anti-thermal aging ability in comparison with the LDPE/SiO 2 nanocomposites, which had the worst anti-thermal aging ability. Subsequently the ability of nanocomposites to ensure the electrical properties was examined by dielectric properties and space charge distribution. The results show that LDPE/MgO and LDPE/ZnO nanocomposites retained the value and the relaxation peaks of permittivity to a certain extent after thermal aging. All of the nanocomposites presented the ability for suppression of space charge accumulation after thermal aging compared with neat LDPE with the observation of obvious homocharges accumulated near electrodes. We find that the interface between nanoparticles and matrix may be the reason for the anti-thermal aging ability exhibited by the nanocomposites.
This paper studied the impact of moisture on the correlated characteristics of the condenser bushings oil-paper insulation system. The oil-impregnated paper samples underwent accelerated thermal aging at 130 °C after preparation at different initial moisture contents (1%, 3%, 5% and 7%). All the samples were extracted periodically for the measurement of the moisture content, the degree of polymerization (DP) and frequency domain dielectric spectroscopy (FDS). Next, the measurement results of samples were compared to the related research results of transformer oil-paper insulation, offering a theoretical basis of the parameter analysis. The obtained results show that the moisture fluctuation amplitude can reflect the different initial moisture contents of insulating paper and the mass ratio of oil and paper has little impact on the moisture content fluctuation pattern in oil-paper but has a great impact on moisture fluctuation amplitude; reduction of DP presents an accelerating trend with the increase of initial moisture content, and the aging rate of test samples is higher under low moisture content but lower under high moisture content compared to the insulation paper in transformers. Two obvious “deceleration zones” appeared in the dielectric spectrum with the decrease of frequency, and not only does the integral value of dielectric dissipation factor (tan δ) reflect the aging degree, but it reflects the moisture content in solid insulation. These types of research in this paper can be applied to evaluate the condition of humidified insulation and the aging state of solid insulation for condenser bushings.
The ability of antithermal aging of LDPE/TiO2 nanocomposites was investigated through SEM, FTIR, DSC, and dielectric properties in this paper. The results of SEM images showed that the thermal aging had a significant influence on the structure of Pure-LDPE and LDPE/TiO2 samples. The measurement of FTIR showed that the content of hydroxyl and carboxyl increased with thermal aging, but the time of emerging aging characteristic peaks for the LDPE/TiO2 samples was delayed. The DSC measurement indicated that filling TiO2 nanoparticles changed the crystallization behavior of LDPE, played a role of heterogeneous nucleation during the process of recrystallization, and improved the crystallinity of LDPE/TiO2. Similarly, the aged LDPE/TiO2 samples had lower permittivity and dissipation factor compared to the aged Pure-LDPE samples. All the results had indicated the LDPE/TiO2 samples had the significant ability of antithermal aging, especially the LDPE/TiO2-0.5 samples with good dispersion of nanoparticles. A new model was proposed to illustrate the antithermal aging behaviors of LDPE/TiO2 samples, which shows that the TiO2 nanoparticles play a role of “crosslinking points” between LDPE molecular chains, increasing the density of crystal structure and reducing oxygen diffusion into materials to break molecular structure.