Many microslits are typically manufactured on quartz substrates and are used to improve their industrial performance. The fabrication of microslits on quartz is difficult and expensive to achieve using recent traditional machining processes due to its hardness, electrically insulating nature, and brittleness. The key objective of the current study was to demonstrate the fabrication of microslits on quartz material through a magnetohydrodynamics (MHD)-assisted traveling wire-electrochemical discharge micromachining process. Hydrogen gas bubbles were concentrated around the entire wire surface during electrolysis. This led to a less active dynamic region of the wire electrode, which decreased the adequacy of the electrolysis process and the machining effectiveness. The test results affirmed that the MHD convection approach evacuated the gas bubbles more rapidly and improved the void fraction in the gas bubble scattering layer. Furthermore, the improvements in the material removal rate and length of the cut were 85.28% and 48.86%, respectively, and the surface roughness was reduced by 30.39% using the MHD approach. A crossover methodology with a Taguchi design and ANOVA was utilized to study the machining performance. This exploratory investigation gives an unused strategy that shows a few advantages over the traditional TW-ECDM process.
Burnishing is a cold working technique used as a surface enrichment to meet the desired surface properties of the workpiece. It improves the visual properties, dimensional tolerances, fatigue strength, surface roughness, and hardness of the work material by applying appropriate pressure through a complex ball burnishing tool to cause plastic deformation. In the current work, the mathematical modeling of the burnishing process was carried out to predict surface roughness by considering the process parameters such as contact radius, penetration depth, and elastic rebound. Further, a customized tungsten carbide (W.C.) insert having a hardness of 80 HRC was developed for the burnishing operation. The micro-hardness of the resulting burnished surface improved from 44 to 48 HRC. The surface quality of the tungsten carbide insert improved by up to 17.1 nm through polishing. Several experiments were performed by selecting appropriate process parameters using developed model feedback. The surface quality of the workpiece improved by up to 45 nm, which resulted in automatic improvements in fatigue strength up to seven times that of the virgin material. The results predicted from the mathematical model were in good agreement (less than 5% deviation) with the experimental results. This study helps to understand the surface formation mechanism in the burnishing process in more detail. Additionally, the achieved results show a significant improvement in the surface finish (~95%), indicating the potential of the burnishing process and how fast and cost-effective it is. The novelty of this paper lies in the improvement in surface roughness and the validation of our mathematical model results with the experimental results.