Electrification of transportation is an effective way to tackle climate change. Public transportation, such as electric buses, operate on predetermined routes and offer quiet operation, zero local emissions and high energy efficiency. However, the batteries of these buses are expensive and wear out in use. The battery ageing is expedited by fast charging and power spikes during operation. The contribution of this paper is the reduction of the power spikes and thus a prolonged battery lifetime. A novel hybrid energy storage system for electric buses is proposed by introducing a flywheel in addition to the existing battery. A simulation model of the hybrid energy storage system is presented, including a battery ageing model to measure the battery lifetime. The bus was simulated during its daily driving operation on different routes with different energy management strategies and flywheel configurations. These different flywheels as well as the driving cycle had a significant impact on the battery life increase. The proposed hybrid battery/flywheel storage system resulted in a battery lifetime increase of 20% on average.
This paper proposes formulating conceptual-stage vessel design optimization problem as a geometric program, which can be transformed into a convex optimization problem. The geometric programming modeling approach offers significant advantages in efficiency, reliability and automation over the general nonlinear optimization methods typically used in naval architecture. Focusing on battery-electric vessels, geometric programming compatible expressions are derived for lithium-ion cells, power converters, propulsion motors, propellers, as well as vessel hull elements. The modeling approach is applied to study optimal battery sizing of a coastal bulk carrier sailing in varying operational conditions. The global optimum is computed in less than a second on a standard desktop computer using open-source software tools. Local sensitivity information encoded by optimal dual variables reveals that increasing the cell discharge upper bound by 1% decreases the optimal total number of cells by more than 1%. This occurs because the higher cell capacity reduces the number of cells, and their total weight, in the optimal solution. The weight saving reduces displacement and resistance, which further reduces the required number of cells.