High speed photodetectors operating at a telecommunication band (from 1260 to 1625 nm) have been well studied with the development of an optical fiber communication system. Recent innovations of photonic systems have raised new requirements on the bandwidth of photodetectors with cutoff wavelengths from extended short wavelength infrared (eSWIR) to long wavelength infrared (LWIR). However, the frequency response performance of photodetectors in these longer wavelength bands is less studied, and the performances of the current high-speed photodetectors in these bands are still not comparable with those in the telecommunication band. In this paper, technical routes to achieve high response speed performance of photodetectors in the extended short wavelength infrared/mid wavelength infrared/long wavelength infrared (eSWIR/MWIR/LWIR) band are discussed, and the state-of-the-art performances are reviewed.
High-speed mid-wave infrared (MWIR) photodetectors have applications in the areas such as free space optical communication and frequency comb spectroscopy. However, most of the research on the MWIR photodetectors have been focused on how to increase the quantum efficiency and reduce the dark current, in order to improve the detectivity (D*), and the 3dB bandwidth performance of the corresponding MWIR photodetectors is still not fully studied. In this work, we report and characterize a MWIR interband cascade photodetector based on InAs/GaAsSb type-II superlattice with a 50% cutoff wavelength at ~5.3 μm at 300 K. The 3 dB cutoff frequency is 2.4 GHz at 300 K, for a 40 μm circular diameter device under -5 V applied bias. Limitations on the detector high-speed performance are also discussed.
20 December 2018 in IEEE Journal of Quantum Electronics
In this paper, we proposed and designed the high speed uni-traveling carrier photodiodes operating beyond 2 μm. InGaAs/GaAsSb type-II multiple quantum wells (MQWs) were used as the absorption region of uni-traveling carrier photodiode to have optical response beyond 2 μm. A rate equation model was developed to study the bandwidth characteristics of this photodiode. The carrier dynamics of the carrier sweeping out process was discussed, and the structure parameters of the quantum wells were optimized. Result shows a 3-dB bandwidth over 40 GHz can be achieved with the optimized design. We also studied the feasibility of dual depletion PIN (DD-PIN) photodiode with MQWs absorber. The optimized DD-PIN photodiode could achieve similar bandwidth under relatively high-bias condition.
High-speed back-illuminated InGaAsP/InP uni-traveling-carrier photodiodes (PDs) at 1064 nm were demonstrated with 3-dB bandwidth of 17.8 GHz at −5-V bias. PDs with 40- $\mu \text{m}$ -diameter deliver RF output power as high as 19.5 dBm at 13 GHz. This structure can achieve low dark current density of $1\times 10^{-8}$ A/cm 2 at −5-V bias and quantum efficiency of 45.2% at 1064 nm. An analytical model based on $S$ -parameter fitting was built to extract parameter to assess the bandwidth limiting factors.
The linearity of high power photodetectors is the limiting factor to the dynamic range performance of analog optical links and microwave photonics applications. In this work, we characterized the third order intermodulation distortion (IMD3) of a uni-traveling carrier photodiode with InGaAs/GaAsSb type-II multiple quantum wells absorber. The 10 μm diameter photodiode shows a third order output intercept point of 36.6 dBm at 200 MHz and 12.9 dBm at 25 GHz, under reverse bias of -5 V and photo current of 15 mA. Combining with the measured device parameters, an equivalent circuit model based simulation is carried out, and the general trend of the simulated IMD3 is consistent with the measurement results. By separately involving the nonlinear mechanisms, the source of the nonlinearity is studied in detail.