Electromagnetic vibroseis is an important seismic wave excitation device. At present, the research of electromagnetic vibroseis mainly focuses on application and prototype design, lacking research on electromagnetic-mechanical coupling. Analyzing the electromagnetic-mechanical coupling and optimizing the air gap magnetic field is of great significance to improve the excitation quality of low-frequency seismic waves. In this paper, the electromagnetic-mechanical coupling is analyzed by studying the parameter force factor, and two novel optimal designs of the air gap magnetic field are proposed. Firstly, the finite element model of the air gap magnetic field is established, and the influence of the force factor distribution curve on the vibration signal is analyzed by using the Gaussian function and parameter spline difference method. Further, an asymmetrical axial dual-magnet design is proposed to enhance the radial magnetic induction intensity in the air gap. The design of adding a radial magnet to the outer yoke is proposed to compensate for the nonlinearity of the in the air gap. The simulation results show that the asymmetric axial dual-magnet structure increases the by 22.2% compared with the axial single-magnet structure. Adding a radial magnet to the outer yoke reduces the amplitude ratio of the third harmonic to the fundamental wave from 23.24% to 4.66%. It is necessary to consider the influence of the height of the driving coils on the maximum displacement, force factor distribution curve, and harmonic distortion.
During modulation, when each phase of subcarriers is the same or similar, the superimposed signal will be modulated by the same initial phase resulting in a large instantaneous power peak, namely the higher peak-to-average power ratio (PAPR). After signals propagate through different paths, the interference is caused by the superposition of each component according to their respective phases, which distorts original signals or produces errors. To reduce the PAPR and resist the influence of long-time delays, we propose to employ the Discrete Fourier Transform Spread Filter Bank Multi-carrier (DFT- spread FBMC) to achieve it. Different from general FBMC technologies, it adds a precoding matrix before the offset quadrature amplitude modulation (OQAM). By comparing with Orthogonal Frequency Division Multiplexing (OFDM) technology, this paper explores its PAPR performance under different delays. The results show that the Pruned DFT-Spread FBMC-OQAM has a lower PAPR and better performance in long-time delays underwater channels.
11 May 2024 in Computers and Electrical Engineering
Seismic communication might promise to revolutionize the theory of seismic waves. However, one of the greatest challenges to its widespread adoption is the difficulty of signal extraction because the seismic waves in the vibration environments, such as seas, streets, city centers and subways, are very complex. Here, we employ segmented correlation technology with Morse code (SCTMC), which extracts the target signal by cutting the collected data into a series of segments and makes these segments cross-correlate with the decoded signal to process the collected data. To test the effectiveness of the technology, a seismic communication system composed of vibroseis sources and geophones was built in an environment full of other vibration signals. Most notably, it improves the signal-to-noise ratio (SNR), extending the relay distance and suppressing other vibration signals by using technology to deal with seismic data generated by the system.