Yogesh Khedar

Mr. Yogesh Khedar


Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
22 January 2021 in Remote Sensing
Verified
Journal Article
Open access
PDF file
YGYahya Ghassoun
Yahya Ghassoun
MGMarkus Gerke
Markus Gerke
YKYogesh Khedar
Yogesh Khedar
JBJan Backhaus
Jan Backhaus
MBMarkus Bobbe
Markus Bobbe
RHRalf Heyen
Ralf Heyen
The regular inspection of the crane tracks of storage cranes at the Container Terminal Altenwerder (CTA), Hamburg requires high accuracy of measurements to determine its position. The allowed tolerances are in the range of 10 mm in the XY plane on a track length of 300 m. The traditional semi-automatic surveying methods are slow and require the interruption of the activities in the storage blocks. The research project AeroInspekt proposed a fully automatic measurement of the position of the tracks using UAV-based photogrammetry. In this paper, the results of the test campaign, carried out in June 2020, were presented where different cameras (150 mm and 80 mm telelens) and flight speeds (1.1 m/s and 1.9 m/s) at a 35 m flying height were performed. Furthermore, an automated rail delineation in the derived surface model was developed and evaluated with ground reference measurements. The results show that the required accuracy of the rail position with an RMSE of 3 mm in XY plane and 8 mm in altitude can be achieved with comparatively less disruption of regular block activities.

6 July 2021 in Atmosphere
Verified
Journal Article
Open access
PDF file
JYJuntang Yang
Juntang Yang
YKYogesh Khedar
Yogesh Khedar
MLMohamed Khalil Ben Larbi
Mohamed Khalil Ben Larbi
JBJan Backhaus
Jan Backhaus
ALAstrid Lampert
Astrid Lampert
ESEnrico Stoll
Enrico Stoll
Unmanned aerial vehicles (UAVs) have been used for increasing research applications in atmospheric measurements. However, most current solutions for these applications are based on a single UAV with limited payload capacity. In order to address the limitations of the single UAV-based approach, this paper proposes a new concept of measurements using tandem flying multicopters as a distributed sensor platform. Key challenges of the proposed concept are identified including the relative position estimation and control in wind-perturbed outdoor environment and the precise alignment of payloads. In the proposed concept, sliding mode control is chosen as the relative position controller and a gimbal stabilization system is introduced to achieve fine payload alignment. The characterization of the position estimation sensors (including global navigation satellite system and real-time kinematics) and flight controller is carried out using different UAVs (a DJI Matrice M600 Pro Hexacopter and Tarot X4 frame based Quadcopter) under different wind levels. Based on the experimental data, the performance of the sliding mode controller and the performance of the gimbal stabilization system are evaluated in a hardware-in-the-loop simulation environment (called ELISSA). Preliminary achievable control accuracies of the relative position and attitude of subsystems in the proposed concept are estimated based on experimental results.