Influence of wastes generated during juice production: apple, carrot and red beet, added to barley straw, on density of pellet mass, pellet hardness, ash content and calorific value was assessed. Dry mass content of additives in the substrate to pellet production was: 0, 10, 20 and 30% of the mixture weight. The relative humidity of the raw material was: 17.0, 19.5 and 22%. Higher percentages of additives and higher moisture content in the raw materials increased the hardness and density of the pellet. The contents of natural polymers such as lignin, hemicellulose and cellulose were determined in primary materials used to prepare substrate and in pellet. Changes in the determination of these substances was observed as a result of the granulation process.
6 October 2024 in Strojnícky časopis - Journal of Mechanical Engineering
The essence of the research is the search for geometric, material and technological limits of the new concept of spinning spindles. Considering the trend of introducing new generation electric drives into the segment of high-speed spinning spindles (over 120,000 rpm), it is necessary to map and describe the basic physical connections, to find the necessary dependencies and correlations of individual design parameters and their limits for the design of a new generation of spindles. Due to the design limitations of the original and years-used spindle drive concept with a belt and the requirement for the production and development of a new generation of spun fibers, it is necessary to expand the basic knowledge for the design of spindles of the new concept, the design of which will be based on the knowledge and dependencies obtained by measuring and examining the basic principles and determining parameters for the design of spindle structures of a new progressive concept.
An analytical solution to the plane problem in elasticity theory is presented for the case of a concentrated transverse force acting on a thin, sufficiently wide plate. A functional relationship is obtained which allow to determine the displacements of points on the plate located along the line of force application depending on the distance from the point of force application. Using an example, by comparing analytical and numerical calculations of the displacement of a specific point, it is shown that the formula derived from the established relationship provides quite accurate results. The proposed formula is recommended for determining the first-order elastic modulus based on measured force and displacement parameters.