Contact time is one of the most important properties for inertial micro-switches. However, it is usually less than 20 μs for the switch with rigid electrode, which is difficult for the external circuit to recognize. This issue is traditionally addressed by designing the switch with a keep-close function or flexible electrode. However, the switch with keep-close function requires an additional operation to re-open itself, causing inconvenience for some applications wherein repeated monitoring is needed. The switch with a flexible electrode is usually fabricated by electroplating technology, and it is difficult to realize low-g switches (<50 g) due to inherent fabrication errors. This paper reports a contact enhancement using squeeze-film damping effect for low-g switches. A vertically driven switch with large proof mass and flexible springs was designed based on silicon micromachining, in order to achieve a damping ratio of 2 and a threshold value of 10 g. The proposed contact enhancement was investigated by theoretical and experimental studies. The results show that the damping effect can not only prolong the contact time for the dynamic acceleration load, but also reduce the contact bounce for the quasi-static acceleration load. The contact time under dynamic and quasi-static loads was 40 μs and 570 μs, respectively.

Squeeze-film damping and acceleration load are two major issues in the design of inertial micro-switches. In order to deeply and systematically study these two issues, this paper proposes a typical vertically-driven inertial micro-switch, wherein the air and electrode gaps were chosen to design the required damping ratio and threshold value, respectively. The switch was modeled by ANSYS Workbench, and the simulation program was optimized for computational accuracy and speed. Transient analysis was employed to investigate the relationship between the damping ratio, acceleration load, and the natural frequency, and the dynamic properties (including contact bounce, contact time, response time, and threshold acceleration) of the switch. The results can be used as a guide in the design of inertial micro-switches to meet various application requirements. For example, increasing the damping ratio can prolong the contact time of the switch activated by short acceleration duration or reduce the contact bounce of the switch activated by long acceleration duration; the threshold value is immune to variations in the damping effect and acceleration duration when the switch is quasi-statically operated; the anti-jamming capability of the switch can be improved by designing the sensing frequency of the switch to be higher than the acceleration duration but much lower than the other order frequencies of the switch.