Existing RFID localization methods typically regard the initial phase of the signal as constant. This is feasible when the antenna and the tag are stationary. However, in synthetic aperture radar (SAR) radio frequency identification (RFID) localization, the relative motion of the reader antenna and tag changes the antenna phase center and tag orientation, resulting in the continuous change of the initial phase. This change, which will cause the non-ideal phase offset (NPO) and thus have an adverse effect on positioning, has been neglected in most previous SAR RFID researches. In this paper, we investigate the antenna phase uncertainty and the tag orientation-dependent phase offset, and analyze their influence on localization accuracy. To the best of our knowledge, this is the first time that the initial phase is regarded as a variable in SAR RFID localization. Besides, a novel motion model based localization method (MoLoc) is proposed, which exploits the relative motion model and visualizes the influence of NPO more intuitively. Compared with the conventional grid-matching methods, MoLoc shows higher accuracy and much lower computational time. Both the analyzes of NPO and the performance of MoLoc are verified by experiments implemented in real scenario. The experiments also evaluate the influence of NPO on the grid-matching method. Experimental results show that NPO has a significant impact on the accuracy of SAR-based localization methods.
30 September 2020 in IEEE Transactions on Vehicular Technology
Device-free localization (DFL) is a hot topic in passive sensing such as intrusion detection, pose estimation and contact-tracing. To improve the performance, we propose a novel fine-grained DFL method using the phase response shift (PRS) to localize targets, which can mitigate the effect of multipath and noise without phase ambiguity. The phases of received multifrequency signals are linearly fitted as the phase response (PR). The shift of target-induced PR with respect to non-target PR is considered as the PRS. The PRSs at every location of the monitored area are observed with different length communication links and are summarized as a PRS weight model. The PRSbased radio tomography imaging (PRSRTI) localization model is derived, and utilizes the PRS and the weight model to localize targets. Experimental results validate that its performance is obviously higher than the received signal strength based radio tomography imaging (RTI).
State-of-the-art radio frequency identification (RFID)-based indoor autonomous vehicles localization methods are mostly based on received signal strength indicator (RSSI) measurements. However, the accuracy of these methods is not high enough for real-world scenarios. To overcome this problem, a novel dual-frequency phase difference of arrival (PDOA) ranging-based indoor autonomous vehicle localization and tracking scheme was developed. Firstly, the method gets the distance between the RFID reader and the tag by dual-frequency PDOA ranging. Then, a maximum likelihood estimation and semi-definite programming (SDP)-based localization algorithm is utilized to calculate the position of the autonomous vehicles, which can mitigate the multipath ranging error and obtain a more accurate positioning result. Finally, vehicle traveling information and the position achieved by RFID localization are fused with a Kalman filter (KF). The proposed method can work in a low-density tag deployment environment. Simulation experiment results showed that the proposed vehicle localization and tracking method achieves centimeter-level mean tracking accuracy.
Device-free localization (DFL) is a technique that can locate targets wearing no devices, and has become an attractive technique for wide applications, such as intrusion detection and gesture recognition. In recent years, research on indoor localization using light sensor mainly focuses on traditional active localization methods, which require photodiodes being attached to targets. In this paper, we explore the visible light-based DFL method. In DFL, shadowed areas caused by different targets may overlap when multiple targets simultaneously exist in a small monitored area, which increases difficulties both in counting target and achieving accuracy localization. This paper presents an accurate geometrical multi-target device-free localization method, which includes a sector ring model and an adaptive multi-target positioning (AMTP) algorithm. The proposed model does well in describing the relationship between the target location and the shadowed area, which provides essential observation information for DFL. The proposed AMTP algorithm improves the accuracy of counting and locating multiple targets through updating weight map of the monitored area in each iteration. Numerous simulation results show that the proposed DFL method effectively achieves multi-target location, and outperforms the traditional geometrical localization method and the fingerprinting localization method both in counting and localization accuracy.
Radio frequency identification (RFID) is a promising technology in indoor localization. However, multipath can not be avoided in indoor passive ultra high frequency (UHF) RFID localization environment, which results in poor localization accuracy. In this paper, a range-based localization scheme has been developed to mitigate the effect of multipath errors and improve the localization accuracy. The proposed localization methods are based on semi-definite programming (SDP) and second-order cone programming (SOCP) and do not require any statistics of multipath error. Firstly, all the phase information of multi-frequency is utilized. Dual-frequency phase difference of all dual-frequency combinations can be obtained to range. The ranging error is assumed to follow the Gaussian distribution. Then, convex relaxation methods with limiting the mean ranging error to one standard deviation of the Gaussian distribution are proposed. Finally, in order to solve the feasibility problem, the constraint of the mean ranging error is relaxed. Simulation results demonstrate that the proposed methods outperform some existing localization algorithms in multipath environment.
Visible light sensing technique has shown great potential in locating human in the building. For indoor positioning using fingerprints, how to reduce the offline labor cost while maintaining accurate location estimation is of vital importance. In this paper, a novel coarse fingerprint-assisted device-free localization (DFL) approach is proposed for locating multiple targets via visible light sensing, which does not need too much calibration effort to build high accurate fingerprint database. Furthermore, a successive cancellation algorithm based on the coarse single target fingerprint database is designed to address the problem of pseudo target positioning in the multi-target DFL. Since the intersection points of shadowed links could not be guaranteed to be symmetrically located around the center of mass of the human body, the estimated location would be biased from the true location of the target. To solve this problem, a convex hull-based localization algorithm is introduced to improve positioning accuracy. Extensive simulation results show that our proposed approach exhibits superior performance in terms of target counting and localization accuracy.