Yongtao Ma

Dr. Yongtao Ma


Research Focus & Metrics

Academic Career Length

19Years (2008-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
21 May 2018 in IEEE Access
Verified
Journal Article
Open access
YMYongtao Ma
Yongtao Ma
BWBobo Wang
Bobo Wang
SPShuyang Pei
Shuyang Pei
YZYunlei Zhang
Yunlei Zhang
SZShuai Zhang
Shuai Zhang
JYJiexiao Yu
Jiexiao Yu
UHF RFID localization technique has been considered increasingly promising in indoor positioning systems. However, conventional localization algorithms are vulnerable in multipath and NLOS environments. To solve this problem, this paper presents an indoor localization method based on angle of arrival (AOA) and phase difference of arrival (PDOA) using virtual stations for passive UHF RFID. We use the array antenna to distinguish multipath signals and choose the two strongest paths according to received signal strength (RSS) to perform localization. The angles of the two paths are obtained through the phase difference of the received signals at different array elements, and the distances of the two paths are estimated through PDOA measurement. After obtaining the angles and distances, we establish virtual stations to convert non-line of sight (NLOS) paths into line of sight (LOS) paths. The possible positions of the tag are calculated through virtual stations, angle and distance information which are derived from the two signal paths. Then the weighted least squares combined with residual weighted (WLS-RW) algorithm is proposed to calculate real position of the tag. Simulation results demonstrate that our method achieves decimetre level accuracy and has higher precision than traditional algorithms.

6 June 2019 in IEEE Transactions on Industrial Informatics
Verified
Journal Article
Closed access
YMYongtao Ma
Yongtao Ma
BWBobo Wang
Bobo Wang
XGXin Gao
Xin Gao
WNWanru Ning
Wanru Ning
The device-free localization (DFL) has promising application prospects in intrusion detection, emergency rescue and smart home, because it does not require the target to carry any auxiliary positioning equipment. Radio tomographic imaging (RTI) is one of the most potential DFL techniques and has many advantages over other methods. However, in passive ultra high frequency radio frequency identification (UHF RFID) scenario, there are few researches and many problems to be solved. The difficult but urgent matter is how to identify the locations of multiple targets from many false targets and artifacts. This paper proposes a novel method based on Cross-Sectional Scan (CSS), Gray Value Distribution Analysis (GVDA) and Naive Bayes Classifier to solve this problem. CSS obtains gray value distributions of the local maximum pixel in a RTI reconstructed image. Then, GVDA extracts several characteristic parameters from gray value distributions, such as the size, height and shape of the peak. Finally, Naive Bayes Classifier utilizes these series of characteristics to judge whether local maximum pixels are false targets or real targets. The method can also recognize the number of targets that are very close to each other. Simulation and experimental results show that this method can accurately determine the locations and the number of targets.

27 March 2019 in IEEE Internet of Things Journal
Verified
Journal Article
Closed access
YMYongtao Ma
Yongtao Ma
CTChenglong Tian
Chenglong Tian
YJYue Jiang
Yue Jiang
Radio frequency identification (RFID) technology, which is one of the important implementation ways of Internet of Things (IoT), has achieved much attention in indoor localization areas. Passive UHF RFID tag localization has a great development recently. Most of traditional passive UHF RFID localization algorithms can only achieve the position of one tag at a time while multi-tag localization is desired in many RFID applications. In the paper, we proposed the weighted Multidimensional Scaling (WMDS) based on received signal strength (RSS) method and the Tag-to-Tag communication system to achieve multi-tag cooperative localization. The targets are marked with passive UHF RFID tags. RSS method is used to determine the distance between readers and target tags through channel models. We can also obtain the estimated distances between target tags by the Tag-to-Tag communication system. The estimated locations of the tags are determined by the calculation of Euclidean distance matrix through a few iterations. Simulation results show that the WMDS algorithm achieves higher localization accuracy than traditional algorithms and the cooperation between tags improves the localization accuracy.

1 April 2020 in IEEE Transactions on Antennas and Propagation
Verified
Journal Article
Closed access
YMYongtao Ma
Yongtao Ma
HLHankai Liu
Hankai Liu
YZYunlei Zhang
Yunlei Zhang
YJYue Jiang
Yue Jiang
Existing RFID localization methods typically regard the initial phase of the signal as constant. This is feasible when the antenna and the tag are stationary. However, in synthetic aperture radar (SAR) radio frequency identification (RFID) localization, the relative motion of the reader antenna and tag changes the antenna phase center and tag orientation, resulting in the continuous change of the initial phase. This change, which will cause the non-ideal phase offset (NPO) and thus have an adverse effect on positioning, has been neglected in most previous SAR RFID researches. In this paper, we investigate the antenna phase uncertainty and the tag orientation-dependent phase offset, and analyze their influence on localization accuracy. To the best of our knowledge, this is the first time that the initial phase is regarded as a variable in SAR RFID localization. Besides, a novel motion model based localization method (MoLoc) is proposed, which exploits the relative motion model and visualizes the influence of NPO more intuitively. Compared with the conventional grid-matching methods, MoLoc shows higher accuracy and much lower computational time. Both the analyzes of NPO and the performance of MoLoc are verified by experiments implemented in real scenario. The experiments also evaluate the influence of NPO on the grid-matching method. Experimental results show that NPO has a significant impact on the accuracy of SAR-based localization methods.

6 February 2017 in IEEE Sensors Journal
Verified
Journal Article
Closed access
ZGZheng Gao
Zheng Gao
YMYongtao Ma
Yongtao Ma
KLKaihua Liu
Kaihua Liu
XMXinlong Miao
Xinlong Miao
YZYang Zhao
Yang Zhao
For radio frequency identification (RFID) system, the location information is very important in many applications, such as Internet of Things, logistics, library management, and so on. Most of traditional RFID localization algorithms can only locate one tag at a time. However, multitag localization is desired in many RFID applications. In this paper, we propose a novel range-free algorithm named nonmetric multidimensional scaling (NMDS)-RFID(F), which combines NMDS algorithm and the fingerprinting localization algorithm to achieve indoor RFID multitag cooperative localization. The NMDS-RFID(F) algorithm firstly uses received signal strength Euclidean distance based on fingerprinting method to get the rank order of the distance for all pairs of tags, and then NMDS algorithm is used to generate the relative coordinates of tags. Finally, due to the coordinates of reference tags are known, we can use the coordinate system registration algorithm to get the absolute coordinates of tags. Simulation results show that the NMDS-RFID(F) algorithm outperforms some previous RFID localization algorithms.

10 March 2021 in IEEE Transactions on Instrumentation and Measurement
Verified
Journal Article
Closed access
YMYongtao Ma
Yongtao Ma
WNWanru Ning
Wanru Ning
BWBobo Wang
Bobo Wang
XLXiuyan Liang
Xiuyan Liang
Device-free localization (DFL) is playing a critical role in many applications which do not require any device attached to the target. Because of environmental changes, the fingerprint database established in the original environments is unable to remain effective when used in the changing environments. Looking at dropout as a prior-knowledge-free data augmentation operation, we propose a convolutional denoising autoencoder (DAE)-based DFL architecture AugRF. Our method combines the merits of the convolutional neural network and the DAE in which convolutional operation is beneficial to feature extraction and dropout operation is equivalent to generating augmented versions of the training data. It is noted that our method can improve the localization performance in changed environments without resampling and retraining processes. Simulations and real-world experiments verify the superiority of the proposed architecture. Our localization system can be implemented with a commercial ultrahigh-frequency radio frequency identification system. When the signal-to-noise ratio of the fingerprint data drops significantly due to environmental changes, AugRF contributes to improving localization accuracy. In addition, the time cost for one positioning meets the requirement of real-time indoor localization.