Temperature sensing is an important parameter needed to be measured by the eSkin during the physical interaction of robots with real-world objects. Yet, most of the work on sensors in eSkin has focused on pressure sensing. Here we present a skin conformable printed temperature sensor with poly(3,4-ethylenedioxythiophene): poly (styrenesulfonate) (PEDOT:PSS)-graphene oxide (GO) as a temperature sensitive layer and silver (Ag) as contact electrodes. The demonstration of PEDOT:PSS/GO as a highly temperature sensitive layer is the distinct feature of the work. The response of presented sensor observed over ~25 °C (room temperature (RT)) to 100 °C, by measuring the variation in resistance across the GO/PEDOT:PSS layer showed ~80% decrease in resistance. The sensitivity of the sensor was found to be 1.09% per °C. The sensor’s response was also observed under static and dynamic bending (for 1000 cycles) conditions. The stable and repeatable response of sensor, in both cases, signifies strong adhesion of the layers with negligible delamination or debonding. In comparison to the commercial thermistor, the printed GO/PEDOT:PSS sensor is faster ( ~73% superior) with response and recovery times of 18 s and 32 s respectively. Finally, the sensor was attached to a robotic hand to allow the robot to act by using temperature feedback.
1 February 2019 in Separation and Purification Technology
This paper presents poly(3,4‐ethylenedioxythiophene) polystyrene sulfonate polymer microchannel (diameter ≈175 µm) based stretchable strain sensor developed inside polydimethylsiloxane substrate. The microchannel diameter changes when subjected to various strains, leading to change in the resistance of strain sensor. The sensor exhibits about three order (ΔR/R0 ≈ 1200) increase in the resistance (R) for 10% applied strain (ΔL/L, L = length of the sensor). This leads to a gauge factor (GF Δ (ΔR/R0)/(ΔL/L) of ≈12 000, which is about ≈400 times higher than most of the reported polymer‐based strain sensors. The sensor is evaluated up to a maximum strain of 30%, which is the standard strain limit associated with human body parts such as fingers and wrists. The sensor exhibits a considerably good average degree of hysteresis (<9%). Further, the sensor is also studied for bending and twisting experiments. A response of (ΔR/R0 ≈ 250) and (ΔR/R0 ≈ 300) is recorded for 90° bending and 150° twisting, respectively. The sensor shows an electrical resolution of ≈150% per degree of free bending and ≈12k% per percentage of stretching. Finally, the potential application of presented sensor in robotics and wearable systems is demonstrated by using sensor feedback from human hand to remotely control the robotic hand movements.
1 December 2018 in Journal of the Taiwan Institute of Chemical Engineers