Hydrothermal alteration minerals are an effective prospecting indicator. Advanced spaceborne thermal emission and reflection radiometer (ASTER) satellite data are some of the most commonly adopted multispectral data for the mapping of hydrothermal alteration minerals. Compared to multispectral data, hyperspectral data have stronger ground object recognition ability. Chinese Gaofen-5 (GF-5) is the first hyperspectral satellite independently developed by China that has the advantages of both wide-width and high-spectral-resolution technology. However, the mapping ability of GF5 data for hydrothermal alteration minerals requires further study. In this study, ASTER and GF-5 satellite data were implemented to map hydrothermal alteration minerals in the Longtoushan Pb-Zn deposit, SW China. Selective principal component analysis (SPCA) technology was employed to map iron oxide/hydroxides, argillic, quartz, and carbonate minerals at the pixel level using ASTER data, and the mixture tuned matched filtering (MTMF) method was implemented for the extracted hematite, kaolinite, calcite, and dolomite at the sub-pixel level using GF-5 data. When mapping the hydrothermal alteration minerals, the distribution features of the hydrothermal alteration minerals from the Longtoushan Pb-Zn deposit were systematically revealed. A comprehensive field investigation and petrographic study were conducted to verify the extraction accuracy of the hydrothermal alteration minerals. The results showed that the overall accuracies for the ASTER and GF-5 data were 82.6 and 92.9 and that the kappa coefficients were 0.78 and 0.90, respectively. This indicates that the GF-5 data are able to map hydrothermal alteration minerals well and that they can be promoted as a hyperspectral data source for mapping systematic hydrothermal alteration minerals in the future.
The Baihetan reservoir region is characterized by complex geomorphology, significant altitude differences, and rugged terrain. Geological hazards in such areas are often characterized by high concealment, wide distribution, and difficulty in field investigation. Traditional identification techniques are unable to detect and monitor geological hazards on a large scale with high efficiency and accuracy. In recent decades, interferometric synthetic aperture radar (InSAR) techniques, such as small baseline subset InSAR (SBAS-InSAR), have been widely applied to landslide identification. However, due to factors such as vegetation and the degree of landslide deformation, single-band synthetic aperture radar (SAR) still has certain limitations in detecting landslides. In this study, SBAS-InSAR was conducted based on ALOS-2 and Sentinel-1 ascending-descending images covering the Baihetan reservoir region. Deformation identification results were utilized to conduct a statistical analysis of the SAR detection performance and landslide characteristics, and the effect of vegetation on the detection effectiveness of different SAR bands was discussed. The study revealed that when surface vegetation coverage reaches a high degree, the percentage of areas with coverage greater than 0.6 is greater than 95%, the SAR coherence is mainly affected by vegetation thickness; the comparison of the difference change in the average coherence of the C/L bands among the four vegetation types shows that the ratio of the average coherence of the L-bands to the C-bands increases by a factor of three with the increase in thickness and the transition from crops to shrubs and trees. The results showed that the L-band has better detectability than the C-band in alpine-canyon terrain with vegetation coverage and complex vegetation composition. However, considering the high temporal resolution and accessibility of Sentinel-1 SAR data, it is still the main data choice for wide-area identification of landslides in the reservoir area, while other satellite-borne SAR data with different wavelengths and resolutions, such as ALOS, can be used to assist in the identification and monitoring of landslide hazards with significant magnitude of deformations and dense vegetation coverage. Therefore, the combined utilization of multi-band SAR data has the potential to enhance the dependability of landslide identification and monitoring, resulting in more accurate detection results.
The Kunming Changshui International Airport was built on complex mountainous terrain with significant fluctuations in Southwest China. The site contains large areas of high fill susceptible to uneven ground deformation from filling material consolidation, dynamic loading from aircraft, and other factors. Thus, monitoring and analyzing the causes and characteristics of postconstruction deformation of high-fill foundations are crucial to the airport's safe operation. In this study, we obtained a total of 149 Sentinel-1A ascending SAR images from March 2017 to March 2022. We estimated the elevation error and corrected the topographic phase to mitigate the impact of large topographic fluctuations on monitoring. Then, we extracted ground subsidence results based on time-series InSAR technology. The results show that deformation mainly occurred in the high-fill areas during the monitoring period, whereas settlement was more pronounced when the fill height was over 30 m. The deformation rate is influenced by the height of the fill, ground reinforcement measures, and dynamic loading of aircraft. Using the Mann-Kendall trend analysis and Pettitt mutation test methods to detect temporal information from time-series points, we found that the time required for the foundation to reach a stable state after construction is not directly related to its residual subsidence. Other factors, such as construction measures also influence it.
On 2 January 2022, an earthquake of Ms 5.5 occurred in Ninglang County, Lijiang City, the earthquake-prone area of northwestern Yunnan. Whether this earthquake caused significant deformation and thermal anomalies and whether there is a relationship between them needs further investigation. Currently, multi-source remote sensing technology has become a powerful tool for long-time-series monitoring of earthquakes and active ruptures which mainly focuses on single crustal deformation and thermal anomaly. This study aims to reveal the crustal deformation and thermal anomaly characteristics of the Ninglang earthquake by using both Interferometric Synthetic Aperture Radar (InSAR) and Robust Satellite Techniques (RST). First, Sentinel-1A satellite SAR data were selected to obtain the coseismic deformation field based on Differential InSAR (D-InSAR), and the Small Baseline Set InSAR (SBAS-InSAR) technique was exploited to invert the pre- and post-earthquake displacement sequences. Then, RST was used to extract the thermal anomalies before and after the earthquake by using Moderate Resolution Imaging Spectroradiometer Land Surface Temperature (MODIS LST). The results indicate that the seismic crustal deformation is dominated by subsidence, with 23 thermal anomalies before and after the earthquake. It is speculated that the Yongning Fault in the deformation area is the main seismogenic fault of the Ninglang earthquake, which is dominated by positive fault dip-slip motion. Meanwhile, the seismic fault system composed of NE- and NW-oriented faults is an important factor in the formation of thermal anomalies, which are accompanied by changes in stress at different stages before and after the earthquake. Moreover, the crustal deformation and seismic thermal anomalies are correlated in time and space, and the active rupture activities in the region produce deformation accompanied by changes in thermal radiation. This study provides clues from remote sensing observations for analyzing the Ninglang earthquake and provides a reference for the joint application of InSAR and RST for earthquake monitoring.