Active control engine mounts employing linear oscillatory actuators are mounted onto automobiles to reduce the frame vibration and noise. In conventional ACMs, the electric power consumption is high, and we clarify the causes of the high electric power consumption by dynamic simulation. Moreover, we propose a new LOA with two movers. The operational principle is described and the effectiveness of the ACM is verified using dynamic simulation.
Nowadays, electromagnetic linear oscillatory actuators are used as vibration control devices because of their high controllability. However, there is a problem that thrust and vibration are small at a wide drive frequency range. In order to improve this problem, we propose a new linear oscillatory actuator that can easily change its own characteristics by using two sets of coils. Through finite element analysis, large vibration was observed at 100 Hz in a series connection, and large vibration and high thrust were observed at 70 Hz and 140 Hz in a parallel connection. From these results, we verified that the actuator had two different characteristics due to switchable connections, and could generate high thrust and large vibration by smaller currents at a wide drive frequency range.
1 August 2016 in International Journal of Applied Electromagnetics and Mechanics
Active vibration control engine mounts are installed in automobiles to reduce vibration and improve ride quality. Previous control methods could be only applied when the phase difference is between -π/2 and π/2. In this paper, a new method that can be used at any phase difference, and that uses step delays so that pre-modelling of the device becomes unnecessary, is proposed. The effectiveness of the method is demonstrated through experimental results.
1 January 2018 in Journal of the Japan Society of Applied Electromagnetics and Mechanics